Just an FYI to anyone ordering a tower from Tashjian Towers..I placed my order in May, was told the end of July, then, the end of August, then, the end of September, now, I was told yesterday (by Kar
OK..has anyone here actually purchased a new tower from Tashjian Tower (not used from somewhere, etc) and if so..how long did it take to get it?..I see lots of comments..no one saying they bought one
OK..has anyone here actually purchased a new tower from Tashjian Tower (not used from somewhere, etc) and if so..how long did it take to get it?..I see lots of comments..no one saying they bought one
OK..So basically..I'll get the tower, etc..Might take a year, year and a half, 2 years..but I'll get it "eventually".Guess that's OK then.....I'll just forget about the order for now...and maybe next
Yes..SteppIR told me 6 to 8 weks..and in 8 weeks I had my product. FYI... Got this email from Tashjian June 2oth: "Tom, I got the status of your order, It is being manufactured the estimated completi
Absolutely..You probably already have a tower...so let's talk about your antenna(s)... Start a thread on antennas & we'll jump on that...(That's a new and unexplored subject anyway, so..) What do you
No more posts for me..sorry I bothered you all.. Later.... -- Original Message -- From: "jimlux" <jimlux@earthlink.net> To: "Bob Maser" <bmaser@tampabay.rr.com> Cc: "Mike Fatchett W0MU" <w0mu@w0mu.co
Dumb question, but.. What bolts are used for the tilt-point bolts (the 2 bolts that provide the pivot point for the tower during the tilt-over...that go thru the tower and tilt...(Since they don't te
Hi, I tried installing my new Rotorcard DXA into my Yaesu 1000DXA controller today. I hooked it up to my PC thru a Belkin Serial to USB connector. I know the connector work's as I use it for another
Joe.. ..I have TRX Manager AND Logic8 both can have rotator control (they are linked)..Problem is I cannot get solid control thru Windows Hyperterminal (terminal program) just calibrating it..I initi
Hi All.. My Yaesu G-1000DXA manual say's to drill thru the mast & put a bolt thru the rotator & mast to keep it (the mast) from turning in the clamp. I was told to do a survey here & get everyone's i
Hi All.. ..Just getting a chance to put my tower up..Got it from Tashjian (& the thrust bearing too)..It came with a choice of grease fittings..a cap, and a screw-in type grease fitting..I screwed in
Thanks for the advice.. I went & bought (at WalMart) a $10 grease gun..and a 3-pk of the Marine/boating-type grease loads for it..Worked great..Also went to Home Depot for a Fernco coupler..didn't ha
Greetings all... I'm checking the A3S I have presently on the new tower (work in progress)..I have the Reflector cranked up about 10 ft from the ground (antenna facing up at 45 deg angle) and get the
They said, in the manual..you could test it facing up a few feet off the ground...Haven't done it at 40 ft yet,, Tom N3ZC _______________________________________________ _____________________________
I threw a connector on the end and used the AEA analyzer with the tower standing up..not cranked up but at 21 ft..and it's still the same..low on all bands... On 20 lowest at 13900(1.63) , on 15M low