Anyone have a leads to 1/2" aluminum bare hardline connectors in type N, F, or UHF? I have some I'd like to get in use instead of mowing around. Floyd Rodgers KC5QBC Multi ended candle burning artist
Ok, last request today, but anyone have leads on connectors for RG333 7/8" aluminum hardline? Phelps Dodge 50ohm type would be the best I could hope for (I think). Floyd Rodgers KC5QBC Multi ended ca
Does anyone have a base for a Tri-ex W51 crankup tower or plans for one? I would also like to find out when production of the W51 ended and specs of the tower. Anyone care to estimate its value assum
I'm looking for one of these short sections too. They are available new, but I didn't like the price or workmanship of the one I saw. Floyd Rodgers KC5QBC Multi ended candle burning artist in trainin
Finally, one I can answer. On the pier drilling machine I used to own, there was an additional blade that used centrifugal force to bell the hole bottom. The trick was turn the auger faster to bell t
Looking for a rotor control box for the G450 yaesu rotor. Anyone have one available. Off list replies please. _______________________________________________ See: http://www.mscomputer.com for "Self
Want to acquire just the control head (have rotor now). Floyd Rodgers KC5QBC Multi ended candle burning artist in training _______________________________________________ ____________________________
Trust me guys, the only way you MIGHT save the bearing is to have a flexible low impedance strap connected to the tower and mast. You wouldn't believe the number of bearings I've seen pitted, melted
Simple, have rotor need controller. _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contes
Ok, time for a side injection from Texas.... Did we forget somewhere when you buy property or anything else, it is supposed to be yours and not the neighbor's. I think somewhere the founding fathers
Something has been bothering me for a while. With all the discussion and problems with tower leg corrosion, filling with water and splitting, etc. Why do almost ALL the manufacturers design the joint
Oops, I may have had too narrow a vison field on this statement. I do need to actually eyeball some of the towers I have on the ground to confirm my oops. I have rohn, heights, and universal towers o
While not a stadium per se, the club I participate with has used a public park with many athletic fields for exactly the same reasons for years. The light standards ~125 feet tall, public exposure, g
The towers are designed for a load at a distance from the base. For us simple minded folks, the load is force times distance (to the base). The difference in 51' or 50'-1" from the base makes dang li
since we are talking copper..... Anyone have a source for flat copper buss bar like that used in industrial applications for ground busses or power busses? I'm looking for something liike 1/4" x 1.5"
In most areas, only 3-4 feet are allowed to hang over the rear/front bumper or the locals start revenue distributon (tickets). Unless you have a rack on the truck that extends beyond the cab, you'll
Alpha delta transitrap also has a high power version Floyd KC5QBC _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@cont
May I suggest you do not use a high strength heat treated bolt as a pin, you would be much better off using 1 or two roll pins. The most important part is to line drill a close tolerance hole through