Bob: Try www.ezhang.com I recommend their square shooter version. I routinely reach 65 feet height 100 feet hoiz. with half tension. Don't need to reach further as lightning and disease eradicated my
Don: You'll have to go east for rotor rebuilding. You received the Pa. dealer. Here is an Al. dealer. http://www.rotorservice.com He will sometimes swap an existing rebuilt HAM IV for your one to be
Chuck: Here's what I pulled off from my antenna shelves. "Scotch Professional Grade 35 White Vinyl Electrical Tape". I color code my many antennas. Plus "Scotch 2228 Moisture Sealing Electrical Tape"
Dan: I'm interested in helping you provide a new home for your tower. I recently moved and brought my tower and beam with me. Plans are laid out. It may be worth using your tower instead. I know your
I am buying a 50 foot 5 section (18 inch triangular) tower plus 10 - 40 meter beam. From Wisc to Asheville, NC 840miles. About 450 lbs. in 10 owner wrapped pieces Uship has offered to transport it on
I normally hang my Balun Designs down and perpendicular to the boom. Call or e-mail on Balun design's website www.balundesigns.com I just look at my 7 el Mosley instructions.It has 12 winds coax tape
*I just to swapped out a tail twister - directional pot went bad. Norms rotor service was suspicious loose cable connector caused my problem. In my rotor plug-in connector was loose. Cause uncertain.
If you desire WWV to remain open you can make your oppinion known at: https://petitions.whitehouse.gov/petition/maintain-funding-nist-stations-wwv-wwvh Also see: https://petitions.whitehouse.gov/peti
*I have been hanging antennas for 50 years. Spent many many hours with ling shots, hard throwing. tennis balls etc.* *Then I came across* *http://www.kr4loairboss.com/ <http://www.kr4loairboss.com/>*
I need to increase a beam section inside diameter about .06 inch. The outside diameter of this Al pipe is1 inch. Mosley was not receiving the element section for a few months. Amazon had the right Al