Hi Steve, Crimp on the regular F type connector on the RG-6 with the proper crimp tool then use the F/PL259 adapter connector . I believe these are available at Radio Shack. Seal with coax seal. I am
Somewhere...recently...I read about using a 'Split Collar' to help hold a mast above the thrust bearing while extending the mast above the tower before installing the rotor. Hope this makes sense? Qu
Hi Guys, Found exactly what I was looking for in Marlborough, MA. For those interested here is URL. http://www.ruland.com/eng_colr.html The SP-32 series is for a 2in dia mast (2" bore) and is $15.93
Anyone know of an East coast supplier of either 1026 DOM or Chrome Moly 2" masting? If this has already been asked a million times, could someone give me the archives date? Thanks, Larry K1UO
I have acquired an estate sale EZ-Way tower (RBX70-3) equipped with a = positive pulldown winch assembly. It is in need of new 3/16 cabling as = the old cable had broken and the tower had some sort o
Thanks all!!!, Many responded and ALL were appreciated. =20 I did like many of the responses suggested and found a local machine = shop to machine some from cold steel...I'll galvanize paint them and
Does anyone know a source for the old military 2in. fiberglass olive = drab (naturally!) masting that came in interlocking 5 or 6 ft lengths? Thanks, Larry K1UO -- StripMime Report -- processed MIME
Thanks all, Many responses and 95% recommended I check with Fair Radio in Ohio. = Soooooooo...just in case others wanted the info and I might possibly NOT = be the only one on the planet that didn't
Wish I had read all those T2X start cap memos.... I have an estate T2X = that wasn't used for a couple years but was new then. I just wired the = T2X up through a new run of 8 conductor cable... 2-#1
Thanks all, 16 replies in short order and ALL say it will work much better than = before! Also, many said that there is no need to remove the cap leads = from the control box, just parallel the new s
I am trying to refurbish an EZ-Way 72ft HD tower and am in need of a = source to change out a couple of wire rope pulleys that have worn down = on one side over the years. EZ-Way is of course out of
I have just become the owner of an EZ-Way RBX-70-3MW tower with very little documentation and definately no information as to getting the concrete base assembly. This tower uses a small triangular to
FYI.... Its here!! Top-Ten Devices has just brought to market the BD-O-SD band decoder and seperate cable to plug directly into the ORION band data jack. The conversion kits to convert your Yaesu Ban
Anyone got a TB-3 thrust bearing they want to part with? Want to add a second bearing inside the tower. Please reply direct to me only. Thanks, Larry K1UO ____________________________________________
All, I am rearranging antennas on a 100ft Rohn45 Tower . A top antenna is the Optibeam 7-2WARC antenna for 17/12 on a 16ft boom and just about 18in above the top plate/thrust bearing is the Optibeam
Not sure about songs but I've said a few "prayers" from time to time concerning Ham radio <8^) item called " relating to _______________________________________________ See: http://www.mscomputer.com
Anyone have a Comtek ACB-160 unit or know of one that might be available? Please e-mail with particulars. Thanks es 73 Larry K1UO _______________________________________________ See: http://www.mscom