Would appreciate Cost info on a HBX 56 tower. A fellow in NC has new one with the three concrete legs and all the bolts. It is still all intact, all sections nested together, as it came from the fact
Several years ago I found out that our local county government here in South Carolina was in the process of drafting a tower ordinance. After viewing the draft copy it was apparent that if it was imp
Fellows, I just did not give it a lot of thought when I sent the = earlier message out with the complete tower ordinance attached. Just did = not realize that attachments would not make it through th
Bruce, I have done the same here with NO problems. I have a Mosley PRO-57 and about 4 years ago I wanted to put my 5 element 6 Meter M2 over it. I very carefully ran a SWR curve on the PRO-57 then pu
Bob, the T2X rotators are very famous for this problem. When it has happened to me I would climb to the beam just above the rotator and rock it back and forth slightly while someone in the shack woul
Hello TT Fans, I have seen some really interesting discussions here over the last week or so about SSB to CW switching or vise versa on 75/80 Meter Dipoles. All this has been good information, becaus
shows rod this I use stainless steel bolts on my equalizer plates..Much Much stronger than normal bolts the same size. Good Luck, Gary, K4MQG List Sponsored by AN Wireless: AN Wireless handles Rohn t
Pete, I have had a Create 2 element yagi up in the air at about 120 feet since 1990 and it has been through every weather condition you can imagine. I also have a 2 element Cushcraft 40 Meter yagi 10
Hello Antenna Guru's, I have a Create 75 Meter two element yagi ( AFA-75) that has recently developed a funny SWR problem. When working correctly the SWR was basically flat at 3790 and had about 100
Rich, a few years ago John, ON4UN, was a house guest of mine for a few days and I had the time to pick his brain about various antenna subjects. One of the questions I asked him was the same as yours
Carl, the replies from KQ2M and K4XS both correct, but there is still another possible cause of the rotor not turning. It is possible that the motor AC starting capacitor inside your control box has
Hello Tower Talk Fellows, .... I will tell you a Hot-Dip Galvanizing story that happened to me in the mid 1970s that you might not want to attempt. Glad I only tried one tower section. I wanted to re
For your info, attached are three pictures showing wind damage to a friends SteppIR antenna in Europe. He said the wind peak was 73 MPH and stayed between 60-70 MPH for three hours. Fortunately he lo
Barry, I have used the 8 Position Remote Coax Switch (RCAS-8) by Comtek for many years without any problems. The same company in Charlotte that makes the superior 4 Square phased array system. Hope t