- 81. Re: [TowerTalk] ALIGNING ANTENNA (score: 1)
- Author: "Gary Schafer" <garyschafer@largeriver.net>
- Date: Fri, 1 Jan 2021 14:39:00 -0600
- But as Joe said, that rotor has only 360 degrees of rotation. You can make the controller look right but you will not be able to make that last 30 degree, or whatever it is off, as the rotor will onl
- /archives//html/Towertalk/2021-01/msg00024.html (16,045 bytes)
- 82. Re: [TowerTalk] outdoor junction shelters (score: 1)
- Author: "Gary Schafer" <garyschafer@largeriver.net>
- Date: Wed, 20 Jan 2021 19:16:53 -0600
- On my 40 meter beam I needed a housing for the gamma capacitor. I used about 18 inches of 4" pvc pipe and put fernco caps on each end. It contains the variable cap and a motor to tune it from the sha
- /archives//html/Towertalk/2021-01/msg00099.html (12,541 bytes)
- 83. Re: [TowerTalk] Wire Antenna Supports (score: 1)
- Author: "Gary Schafer" <garyschafer@largeriver.net>
- Date: Tue, 16 Feb 2021 22:10:11 -0600
- I have an old Ezway 40 foot crank up/tilt over tower that is mounted on what they call a "Wonder post". The post is about 4 or 5 inches in diameter (steel) and 9 or 10 feet long. About 5 feet goes in
- /archives//html/Towertalk/2021-02/msg00093.html (12,371 bytes)
- 84. Re: [TowerTalk] RF Surge Suppressor at Base of Tower or Shack SPG or Both ? (score: 1)
- Author: "Gary Schafer" <garyschafer@largeriver.net>
- Date: Thu, 14 Oct 2021 21:52:52 -0500
- You need to have the tower bonded to your house electric ground for NEC compliance. To the question of the AC entrance on the other side of the house, the easiest way to deal with this is to run an A
- /archives//html/Towertalk/2021-10/msg00082.html (11,511 bytes)
- 85. Re: [TowerTalk] AFCI RFI? (score: 1)
- Author: Gary Schafer <garyschafer@largeriver.net>
- Date: Thu, 16 Mar 2023 13:09:43 -0500
- I went thru about 3 sets of Eaton breakers. The problem was not rf but with surge current when I would turn the radio on, they would trip. I finally took them out and put in regular breakers. Know th
- /archives//html/Towertalk/2023-03/msg00020.html (10,746 bytes)
- 86. [TowerTalk] Tilt plate new owner (score: 1)
- Author: <garyschafer@largeriver.net>
- Date: Mon, 1 May 2023 12:49:56 -0500
- Can someone give me the web site for the new owner of the tilt plate? Thanks Gary K4FMX _______________________________________________ _______________________________________________ TowerTalk maili
- /archives//html/Towertalk/2023-05/msg00000.html (5,918 bytes)
- 87. Re: [TowerTalk] Diagnosing a stuck rotator (score: 1)
- Author: Gary Schafer <garyschafer@largeriver.net>
- Date: Tue, 12 Dec 2023 23:22:04 -0600
- I had an Orion that was intermittent and it turned out to be a bad reed switch. Gary K4FMX _______________________________________________ _______________________________________________ TowerTalk ma
- /archives//html/Towertalk/2023-12/msg00027.html (13,145 bytes)
- 88. [TowerTalk] Coax cable stripper (score: 1)
- Author: <garyschafer@largeriver.net>
- Date: Thu, 8 Feb 2024 21:29:12 -0600
- What is a good coax cable stripper? Thanks Gary K4FMX _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com h
- /archives//html/Towertalk/2024-02/msg00014.html (6,314 bytes)
- 89. Re: [TowerTalk] LMR-600UF ? (score: 1)
- Author: Gary Schafer <garyschafer@largeriver.net>
- Date: Fri, 21 Jun 2024 10:00:27 -0500
- I just put up a couple of runs of lmr 600 for my satellite antennas. I bought some split wire loom (1) and placed it over the cables for uv and abrasion protection. Gary K4FMX _______________________
- /archives//html/Towertalk/2024-06/msg00088.html (8,095 bytes)
This search system is powered by
Namazu