- 1. [TowerTalk] Powering rotator w/ battery - field day (score: 1)
- Author: aa2gs@isoc.net (Russ Connors)
- Date: Mon, 21 Jun 1999 11:05:22 -0400
- I'm going to run Field Day from home w/ only batteries and generator (during the day) . I am concerned about power requirements of the rotator (HAM IV w/ 200 ft of wire). I have a 250W inverter, but
- /archives//html/Towertalk/1999-06/msg00225.html (7,117 bytes)
- 2. [TowerTalk] Coax suggestion (score: 1)
- Author: aa2gs@isoc.net (Russ Connors)
- Date: Mon, 03 May 1999 18:03:36 -0400
- Looking for a suggestion for a good coax type to connect my KT-34A to remote antenna switch. The cable will need to be abt 80 ft. I've used 4XL but it seems I always end up w/ water in it. I've been
- /archives//html/Towertalk/1999-05/msg00068.html (7,453 bytes)
- 3. [TowerTalk] TX-455 - Do slopers work w/ it?? (score: 1)
- Author: aa2gs@isoc.net (Russ Connors)
- Date: Mon, 07 Dec 1998 17:20:40 -0500
- I'm interested in attaching a 1/4 wave sloper for 160m work to the top of my new TX-455 crank up tower. I did about the same as I did for my old Rohn 25 and the results were very poor. I suspect that
- /archives//html/Towertalk/1998-12/msg00086.html (7,048 bytes)
- 4. [TowerTalk] TX-455 raising ideas (score: 1)
- Author: aa2gs@isoc.net (Russ Connors)
- Date: Tue, 03 Nov 1998 10:33:23 -0500
- Is there another point higher up on the lower tower section that a wire rope could be attached, rather than the point used for the rasising fixture (which I don't have)? I have a convenient tree near
- /archives//html/Towertalk/1998-11/msg00055.html (7,306 bytes)
- 5. [TowerTalk] Buried Coax (score: 1)
- Author: aa2gs@isoc.net (Russ Connors)
- Date: Fri, 10 Apr 1998 16:48:03 -0400
- I have a 250 ft run to make to my tower and would like to buy the rotor and feedline cables. Any suggestions for type of coax? Should I bother w/ conduit? Thanks, Russ AA2GS -- FAQ on WWW: http://www
- /archives//html/Towertalk/1998-04/msg00264.html (6,979 bytes)
This search system is powered by
Namazu