Hi Jorge, If you get a PDF of this article (or some other electronic form}. I would like a copy too. I went to their website, but it's not available. Thanks and 73, Tommy W7RV _______________________
Bill, You can download it from the Hy-Gain website.....the conversion info is in the regular 204BA manual. It's a four element, by the way. _______________________________________________ ___________
Hi Felipe, I looked in my manual and same thing (just says motor cap).............there is a Hy-Gain part number, but you have that in the manual. My manual shows the motor at 24VAC at 9.0 amps. I do
Mike, I would look at the 1300 lb rated "Hoist" from Harbor Freight. It uses wire rope not chain and is designed for overhead lifting. Several people in the Phoenix area have fixed these to crankup t
The 80 lb bag was 0.90 cu ft, so you can scale it down. W7RV _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contestin
Folks, I am in dire need of this maual. I have the RC5A3 manual, but the B3 is quite different, mechanically and electrically. Know where I can download it or can you scan it for me. I googled for it
Hi Bill, If a HAM-IV rotor will not fit in the top section, then it is not a CZ-471. 73/Tommy W7RV Hi folks, I acquired a tower that has a data plate on it saying that the tower is a Tristao CZ-471.
All my wenches are adjustable.......they get attitudes and you have to adjust them. Tommy W7RV A screw driver through the hole at the end of 12" adjustable wench held at eye height , was the sight li
Paul, On BAMA - Edebris , there is a manual for a model 50, 5 position Antenna Mart Remote Switch. Hope that helps. 73/Tommy W7RV Anyone on the list have a schematic or manual for the Antenna Mart se