Hello, Is there a MIL SPEC or an outer jacket material spec for RG8 type coax that will be directly buried in the ground? Tnx. 73 de Stokley, W3SB -- FAQ on WWW: http://www.contesting.com/towertalkfa
Hello, I remember seeing a note from a W7 (I think) who sold Rohn tower parts. I need some bolt sets for Rohn 25G. Anyone have that info? Tnx. 73 de Stokley, W3SB -- FAQ on WWW: http://www.contesting
Hello, I am contemplating taking down my 10-year old 50 ft Rohn 25G tower and replacing it with 70 ft of Rohn 45G. My reasons are twofold: 1) get the Cushcraft A4 up higher and 2) stack a dualbander
Hello, After 18 years of faithful service, my Ham IV is in need of an overhaul -- I'm getting intermittent meter indication and I suspect the potentiometer is in need of cleaning or replacement. I've
Hello TT'ers, I have read the notes in the archives regarding locating the AS25G accessory shelf within a straight section. Consensus is that it can be done one of two ways: 1) by notching the plate
Hello TT'ers, I need to degrease some parts prior to painting. Metal degreasers such as PCE, TCE and 2-butoxy ethanol are hazardous and are better left to the industrial environment. What health / en
Hello TT'ers, I am changing out my Ham IV (circa 1979) rotator with an AlfaSpid due to changes in the tower setup (stacked beams). The unit was overhauled about 2 years ago by C.A.T.S. (aka "Rotor Do
Hello TT'ers, Handyman special...15 year old Rohn TB-3 thrust bearing AS IS. It MAY or MAY NOT be repairable but the price is right...$10 plus shipping. The exterior is fine and the mast bolts are ou