Author: mike@hatzakis.net (Michael Hatzakis, Jr MD)
Date: Tue Aug 19 07:16:27 2003
I though I would contunue my campaign in support of ham radio towers here in Seattle. I've got a letter from the city council I should respond to regarding my Tower permit and thought it would be a n
Hi Towertalk, Well, as I mentioned, I managed to get by the hurdle of the building permit and the CC&R, but now dealing with a harrassing neighbor. I appreciate all your help getting me here... First
on closer look, the card that was left at my door says she is a code complaince inspector not a land use person. So, you may be right. They did admit during the application process that they had no j
A number of you asked for a follow up. Once in a while, it's good news.! I called the city dept of code enforcement this am. As I suspected, it was a complaint the officer had to follow up on. She as
I had a thread on here a while ago about motorizing a US Tower MA-550 crank up tubular tower. I am about to buy from Grainger a Dayton model 4Z327B (115vac 6amp) electric winch to replace the hand cr
<<<< The following e-mail bounced back again, right after I received your reply. Terry, is <<<< it possible that your "reply-to-address" is different than your real address?? Terry, Thanks for the fe
I just bought a used HAM V rotor with the wiring all reversed and upsidedown and trying to figure out if it is actually working properly or if it is damaged. Can someone who has the rotor and control
Thanks to all who responded to my question. As a result, I found the proper documentation and now found I have a burned potentiomoeter, at least. Does anyone know from where or how I might buy a repl
Group, The tower I've been talking about and planning for over a year now has finally gone up. Note the phylistran rope keeping the D40 from sagging. It does a nice job. Cushcrafts D4 truss never mad
if you have broadband will send you the slides for my base, from groundbreaking to concrete pouring I am ready to install a new U.S. Tower TX-455 55-foot free-standing tower. I previously had one of
Just got a Cushcraft D40 to go on top of my Steppir at around 75'. A few novice questions. First, trying to tune it prior to installation. A few feet above the ground, it's resonance is 6.8mhz, about
Great ideas, thanks for all the responses. I have been testing my D40 on a tv roof support and a tv mast on the ground about 16 feet up. (which probably explains the problems tuning). I misjudged how
I posted this on the antennaware refelctor since I just realized that this is a more appropriate place for this question. Respond to me directly here or on the AntennaWare post. Thanks, Michael K3MH
I am looking for a 15-20' foot version of same, do you know where I can find one? --Original Message-- From: towertalk-bounces@contesting.com [mailto:towertalk-bounces@contesting.com]On Behalf Of Rob
Group, Turns out what I recently bought is likely not a US Tower MA-550 but an old Wilson T55 tower which is very similar, but not exactly the same. Does anyone have any experience working with this
this is a very timely question, I'd like to be cc:'d on this response. I need a good 40 meter rotatable dipole I can add to a tribander that isnt too huge, is this close to what you were asking about
A very big thank you to all of you that have been so supportive with information and details for my tower install. I have been struck by how many legal, structural, political, technical and social de
I would like to hear from those of you that have managed to retrofit a motor onto the crank of a manual crank up tubular tower, such as the US Tower MA-550. What kind of approach did you use and wher