Anyone use this cable manufacturer? Made in Mississippi.... I'm considering using them for my main tower runs.... maybe split a reel with someone. www.trilogycoax.com 73, ______________________ Cl
No sir... "Trilogy was incorporated in 1985 as a buyout of a division of General Cable. All of Trilogys AirCellŪ Cables are produced in a 225,000 square foot manufacturing facility in Pearl, MS." htt
I've not yet gone that far down the road. For folks who are used to scrounging reel ends at Hanfests, I am sure it will be considered expensive. <wink> Cost is why I am looking at buying a reel and
Thank you.... I would only be using the big Trilogy stuff for main runs of hardline on the tower or other places appropriate to the hardline and larger bending radius. I've never minded paying for t
Wow.... with that much potential repair cost, I would replace that bolt with a cross-drilled bolt-head and safety wire it. ______________________ Clay Autery, KY5G (318) 518-1389 On 07-Jul-18 22:23,
One of the top reasons that I make ALL my own cables if at all possible... No substitute for quality materials, combined with the proper tooling, and a healthy dose of OCD. 73, ______________________
Also, the AlphaSpid RAK and Big RAK allow you to put the rotator pretty much wherever you want in the tower, generally the lower the better. Additionally, instead of the pin base plate, you can run a
Used them in a race car I built one time for all the Autronics compute signal and power wires... Worled great, and loads better than OE automotive connectors. You DO need to pay particular attentio
Love those folks!! Buy everything I can from there. 73, ______________________ Clay Autery, KY5G (318) 518-1389 73 Jim W7RY --Original Message-- From: TowerTalk [mailto:towertalk-bounces@contesting.
Use the largest diameter wire for which you have sufficient length. I use #12 wire in my 80 m loop horiz delta... There has been little stretch in the years I've had it up, and sag is minimal. I o
Actually, there are VERY high quality F-connectors available with gold plated center pins (crimp and/or solder), ptfe insulation, et al.Canare makes excellent broadcast quality cable and connectors i
Thanks, Mark... Apparently, I lack markup experience for this list. <blush> The proper URL is: https://montac.com/ha/heights_antenna.htm 73 all! ______________________ Clay Autery, KY5G (318) 518-1