Somewhere in the ads for the sale it was stated that the trailers had TX licensing, with plates....That should get you home OK . ..after all, look at the U-Haul trailers! 73 Mark AA6DX --Original Mes
In the wayback, the 70s, I had a Wilson DB-54 which I was quite pleased with .. not so hot on 15m, but pretty much a laser on 20m! Had a 6 L 10m Wilson on top of mast -- worky worky! You might look f
In the wayback, we called the product "Antenna Fuse" == fine 100 watts, but even a Heath SB-220 could fry them -- I know, hating climbing the tower in a November contest to take the "fuse" out of the
This stuff MUST have some great applications tower, antenna, rig? 73 Mark AA6DX https://www.amazon.com/Copper-Conductive-Adhesive-4inch-36yards/dp/B01CH4LYZ6/ref=gbps_tit_s-3_596a_478c2427?smid=AQFE7
https://mendocino.craigslist.org/clt/6039585236.html Would wager this is NA6T great buy! 73 Mark AA6DX _______________________________________________ _______________________________________________
In the meantime -- you might try a 1/4 sloper -- don't mount it at the very top of your tower/pole -- about 6' down worky worky! You might be pleasantly surprised! 73 - Mark AA6DX --Original Message-
I have used a fence type bubble level many a time, and never a problem..has two sides, and easy to move position. Uses rubber bands to keep in position when wanted. Available in the ten dollar range
Well -- here we go again. Way to paint fiberglas pole is to purchase a cheeeeep pvc pipe of adequate size, along with one end plugged -- put paint in, dip pole/spreader .. pull out, drip dry, pour le
NO, & NO -- I have 2 of those battery irons, and had terrible luck using them on a tower -- matter of fact, I don't even know where they are right now! HIHIHI.. BUT -- I also have a butane iron, and
24 Hour Flash Sale - Save 10% on All Soldering Tools and AccessoriesIf you insist on cordless soldering equipment, here is a today only sale !! 73 Mark AA6DX 24 Hour sale - Save an additional 10% on
I have a 40/80 droopy on air as I type, using an ugly balun -- it worky worky. in the way-back, I tried to incorporate 20M on that single coax connection .. that screwed all 3 bands up to the point o
Copper strap, and soldered with Mapp Gas... Mark AA6DX (NOT COPPER WIRE!) Hi John, The intermediate grounding kits are almost always bolted to lugs on galvanized brackets welded to the tower itself.
RRR -- Big wire works fine. Don't be thinking of only "Rotator Control Cable" -- Locally Romex was the least expensive route. Then go to rotator wire at each end, like into the shack and at the base