Remember a number of comments on this subject. Mine stopped working... sometimes it will bounce between 0 and -10 but that is about all. I can set up the remote POD for RIT XIT and it works great fro
Jerry: Sometimes excising the knob will make the encoder start working again, at least for awhile. The long and short of it is that you will probably have to replace the encoder. Ron N6IE www.N6IE.co
I had this problem until the rig went in for other work to be done (the usual replacement of C6, C7 and C9 on the power board). On a previous visit they had been unable to trigger the intermittent fa
Jerry, I have had this problem off and on since 2004. I found that if I hit the pins of the RIT/XIT encoder with some heat and a bit of solder, it cures the problem. But many times it has shown up ag
Reg - I sure would like to know the details of that fix, which in-line components, which traces, and which resistor. I've had the same problem. Tried re-soldering the pins, helps for short period. Tr