I am wanting to calibrate the BFO oscillators per page 4-43 of the manual. I cannot get my frequency counter probe into the small RG-174 jack at Connector 46 of the TX audio board. So, I suppose I ne
I've always just used clip leads. Barry N1EU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
TMP connectors? Try Inrad and other other suppliers. Pete http://www.inrad.net/home.php?cat=163 _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.
Look to the left of the jack. There are two resistors and you can hook on to the second to the left of the jack. One side is ground and the other hooks to the jack. I have been told there are seve
I've found it easiest to clip on to the end of a resitor located near the connector. I also suggest usng a 10X probe from my scope to connect to the input of the frequency counter. I do suggest you f
Thanks for all of the good suggestions -- I appreciate it. 73, Reed WI9P Re: OMNI VI TX Audio Bd Connector 46 Test Lead Message: 3 Date: Tue, 14 Jan 2014 17:57:34 +0000 From: Barry N1EU <barry.n1eu@g