- 1. [TenTec] High current (score: 1)
- Author: John Molenda <cdistflatfoot@gmail.com>
- Date: Wed, 13 Mar 2013 22:09:50 -0400
- can anyone tell me the meaning of the High current flashing on the screen of my omni vii on cw . thanks John kb2huk _______________________________________________ TenTec mailing list TenTec@contesti
- /archives//html/TenTec/2013-03/msg00162.html (7,143 bytes)
- 2. Re: [TenTec] High current (score: 1)
- Author: Carl Moreschi <n4py3@earthlink.net>
- Date: Wed, 13 Mar 2013 22:21:31 -0400
- It means that your current in the finals is very near the point where the radio will shut down. Carl Moreschi N4PY 121 Little Bell Dr. Hays, NC 28635 www.n4py.com On 3/13/2013 10:09 PM, John Molenda
- /archives//html/TenTec/2013-03/msg00163.html (7,888 bytes)
- 3. Re: [TenTec] High current (score: 1)
- Author: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
- Date: Wed, 13 Mar 2013 21:39:29 -0500
- Also likely means that the SWR is 3:1 or higher and that the reactive component of the Z is much less than 50 ohms. Maybe in the order of 15 ohms or so. Anyway, Carl is correct in that the shut-down
- /archives//html/TenTec/2013-03/msg00165.html (8,672 bytes)
- 4. Re: [TenTec] High current (score: 1)
- Author: Richards <jruing@ameritech.net>
- Date: Wed, 13 Mar 2013 23:25:50 -0400
- Right. Check your whole setup. Check the antenna; the connections (are they free from shorts and have good continuity, and are they all snugged up; check your microphone and other connectors; check t
- /archives//html/TenTec/2013-03/msg00166.html (8,274 bytes)
- 5. Re: [TenTec] High current (score: 1)
- Author: "denton" <denton@oregontrail.net>
- Date: Wed, 13 Mar 2013 20:30:18 -0700
- ..or a relay on the low pass filter board is getting a little flakey in the Omni... That's very similar to what my Omni 7 was doing on 12 and 10 meters..intermittent relay failure. Finally the relay
- /archives//html/TenTec/2013-03/msg00168.html (8,922 bytes)
This search system is powered by
Namazu