- 1. [TenTec] Help--New Omni D Ser B owner needs help (score: 1)
- Author: Scott Sheppard <scottsheppard@videotron.ca>
- Date: Thu, 17 Feb 2005 22:28:39 -0500
- Hi folks, I just picked up a TEn-Tec after wanting one for many years. The rig rec's fine and does key but there is no RF out. Thee is a very weak signal present from the low level board but very wea
- /archives//html/TenTec/2005-02/msg00528.html (7,843 bytes)
- 2. Re: [TenTec] Help--New Omni D Ser B owner needs help (score: 1)
- Author: "Tommy" <aldermant@alltel.net>
- Date: Sun, 20 Feb 2005 00:13:35 -0500
- Scott.... Check the soldering on the bottom of the board where Q3 is located. Older Ten Tec rig's are infamous for bad soldering joints. Good luck with it. ___________________________________________
- /archives//html/TenTec/2005-02/msg00534.html (9,056 bytes)
This search system is powered by
Namazu