OK, risking the firestorm from the Orion and the Heil crowd, here goes! (Let's keep responses to technical discussion, OK?) When I attempt to use my ProSet with an OLD Ten-Tec adapter (about 8 years
This may sound silly, but instead of going through adapters, etc., I removed the Icom connector from my ProSet and used the four-pin TT connector. Results were no problem at all using the ProSet with
Duane, Hello my friend, well I can tell you what works here. I have a Heil Goldline with the standard Heil TT cable, works fine EXCEPT on 10 mtrs when I use 400 watts out, I get lots of RF feedback (
Lee - Mine is only about 8 weeks old, so I'm assuming it has the ground connection made at the connector. I'm looking more at whether modifying the Heil adapter will solve the problem. I'll probably
If you have RF feedback, it may be a pin 1 problem. Cable shields should go to the chassis, NOT to the circuit board. All the TenTec gear I have takes them to the circuit board and not the chassis, w
What Mods are you speaking of on the Heil cable? Lee _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
Quote from the manual addendum: "The microphone cable shield must be tied to the transceiver's microphone connector shell. That is normally done by clamping the shield runner under the strain-relief
Duane, I can confirm that the standard Heil TT cables are not wired that way. I have had mine apart. Unfortunately in the case of the Heil Goldline a Mod inside the Mic is also required to have the M
Duane, Perhaps this link on the Heil web site will help you and others visualize what is needed to properly ground your mic shield on the Orion. This seems to work for me. http://www.heilsound.com/ha