OK, Jim, Best for you to make two columns of pin numbers. Make first col. the MC 50 kenwood list of 1 to 4. Then the next column are the pins to use on the Ten Tec Scout connector. What I did for a s
A couple of corrections in my post "mail" should be male. the impedance change is done where the mike cable plugs into the Kenwood mike tube, not on the desk base itself. Just ignore if you were not
Thank You very much, I use at cabin and the Scout does work well. I will let you know it works out and thanks again for the info. 73 Jim and the Girls ________________________________ From: Stuart
On 7/26/2013 5:24 PM, Stuart Rohre wrote: What I did for a similar case was to buy an inline female connector, and cross wire it with Scout mail connector. That way, you keep the Scout standard Ten T
Thanks, That's is what I did and works ok, I will get some reports on the Ten Tec net tomorrow. 73 Jim and the Girls This mirrors my own suggestion to make an adapter patch cable with a very
Great ! Nothing like the heady sense of self satisfaction that comes from a successful home brew project. Hope to catch you on the Net. -- K8JHR -- Thanks, That's is what I did and works ok, I will g