Date: Mon, 31 Dec 2007 11:02:56 -0500 (Eastern Standard Time)
I need the 25 amp bridge replacement for a 962 ps. Ten Tec no longer has the exact replacement and a mod would be needed as I was told. Not a big deal but if I can find the exact sub, the unit can be
Lew, Try Mouser Electronics. I bought several from them last year. Pat Haynes-K4BEH _____________________________________________________________ Click here to save up to 75% on disability insurance.
Mouser has them. {now if I could just find my Mouser catalog I'd give your the part number} Mouser.com and search. 73 Bob, K4TAX _______________________________________________ TenTec mailing list Te
Date: Tue, 01 Jan 2008 16:48:19 -0500 (Eastern Standard Time)
Thanks again for the info. A few have said the part is available but no one seems to know the brand or part number? If anyone remembers it would be great. Happy New Year again to everyone! Lew-KlNDV
Author: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
Date: Tue, 01 Jan 2008 17:06:12 -0600
Is there a part number on the part? What's it look like? Most 30 amp bridges are in a square aluminum package or molded package with terminals in the four corners sticking out perpendicular to the pl
The problem with the NTE replacement is that two of the tabs are turned 90 degrees and won't fit the PC board slots. Some of the other mfrs are same way. Phil Chambley, Sr. k4dpk ____________________
How about this: GBPC3501 $2.92 in single lot qty. From Mouser Manufacturer data sheet: http://www.fairchildsemi.com/ds/GB/GBPC3501.pdf 35amp, 100 PRV. It is a real generic non-critical part. Now what
Author: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
Date: Tue, 01 Jan 2008 20:21:24 -0600
I've never seen the supply so I can't see that from here. But in my NTE catalog there are two layouts for flat lugs and one for round wires. The layouts for 25 amp and 40 amp flags are different. The
Author: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
Date: Tue, 01 Jan 2008 20:28:28 -0600
Now he says it plugs into the PC board and the NTE lugs don't line up with the slots in the board. In the NTE catalog I see two post arrangements and one with round wires. I can't tell from here whic
Mine has the FW Bridge mounted on the bottom of the chassis with wires going to it. 73 Bob, K4TAX _______________________________________________ TenTec mailing list TenTec@contesting.com http://list
I must be thinking about a different T/T power supply, since I have worked on quite a number. Tell you what, I'll just with-hold my comments and that way you fellows can solve these problems without
Date: Wed, 02 Jan 2008 02:16:54 -0500 (Eastern Standard Time)
Yes, I removed the blown block from the 962 supply. It indeed was soldered directly through the circuit board. I kept solder sucking the solder off then finally cut the terminals off the bridge and r
Author: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
Date: Wed, 02 Jan 2008 11:01:44 -0600
Have you looked at the alternative pin arrangements at www.nteinc.com? I think not. They do have three variations. One with round wires almost in a square, and two with flat spade lugs. One arranged: