FWIW I've seen sellers offer a Scout with a set of modules. Typically, not all of them, only to have it sell and reappear a week later for auction again. This time it's a Scout with one module and th
Has anybody paired the Hercules II (or any other TT amp) and MFJ-998 legal limit autotuner. I am curious if the tuner works with the keying enable that Ten Tec uses. The diagram on page 5 of MFJ's do
I remember the furor of IC-706 buyers when the IC-706MK II came out. It was repeated when the IC-706MK II G came out. A similar thing happened each time they spun out a new IC-756/Pro/Pro II/Pro III.
I know of a blind ham that used a Kenwood TS-570 with the auto-tuner and voice board. He got around very well with it. You may be able to get your best info from the Handi-Hams http://www.handiham.or
I am restoring a Triton II and in recent on the air trials on 80m, I noticed that the RIT changes the TX freq +/- 200 Hz. The RX frequency change is substantially more (10X or so...varies with band).
I have had good luck with http://www.trueladderline.com/ I ordered a antenna and feedline from them. I use it for my Argonaut 509 through an Elecraft T1 Transmatch and the Elecraft switchable balun.
Hello All, I recently lost a Triton II, Triton IV, RX320, Ten Tec Omni 6 (plus via opt. 3), 962 power supply and a Hercules II/9420 power supply to a lightning strike. All antennas were disconnected.
If an Orion 3 or Eagle II comes about, I'll probably get in line for a used Orion II. I like my classic Orion and an O2 might become more affordable once a follow-on rig comes forward. I have to say,
I wish the RX-366 was leveraged into a standalone RX or even a support platform that we could plug our old Orion sub-RX (the ones pulled to make way for the RX-366). The old sub-RX was a good SWL rec
I use the LP-PAN2 with the Creative 0204 USB sound card. For software I use N4PYand NaP3 2.7. It all plays together nicely. It ties into N1MM logger as well. Point and click QSY is handy in Search an
I am curious about what members of the list are using for their wide roofing filter in the RX-366. At this time, with CW as my main interest, I have a 600Hz and a 300Hz in place in mine. I have littl
I want to thank everybody for their responses. I had often seen the "all roofing filter positions filled" or "fully loaded with filters" and was wondering what I was missing. I think I will roll alon
I recently had to replace my power cable as well as the Mate-N-Lock connector inside my Orion. The pins had gotten burned on the surface and no amount of clean-up made a reliable connection. I am try
I have laid out the band decoder using the Orion band output to BCD option that works with the KPA500 amplifier. I used ExpressPCB.com with their "MiniBoard Service" option. The board is 3.8" X 2.5 i
Thank-you for the responses. Both boards are spoken for at this point. -- Carl R. Gansen WB0CFF 9300 W225th Street Belle Plaine, Mn 56011-4206 _______________________________________________ TenTec m
I have been looking for a solution here as well. None has been found so... I am tinkering with the idea of using a virtual port from N4PY linked to a serial port on an Arduino or ChipKit Uno board an