I'm exiting the hobby for the foreseeable future. The following Ten Tec items are offered for sale on this list before going to auction. A rough photo of the complete station is available on the QRZ.
This may be known to several of you but for those of you who buy or sell Ten-Tec gear on eBay, there appears to be another really slick trick being used to scam bidders: A couple days ago, I received
You can still have a PIN diode failure in the middle of a contest if the antenna system begins breaking down. For me the question is reduced to the operating environment at the station. If there is
this, please chime in! It turns out there's an easy way to rule out PLL timing issues and whether you're on logic chip V1.02, V1.03 or any other logic chip for that matter... If you remove the back
For a point of reference, I can clearly hear band noise between dits at 35WPM with V1.02. I would consider about 40 WPM on this rig to be the upper useful limit if one must hear between keyed elemen
There were far too many replies to answer each one individually. The mod consists of unplugging connector 52 on the I.F./A.F. Board. = That's it. Plug 52 should have only one wire attached to it. Th
Speaking of AMP Mate-N-Lock connectors, does anyone know if a locking version of the Anderson Power Pole connector is available? The AMP connectors work reasonably well, but the fit between mating c
I see a large gray PC tower case with a DVD drive and Hitachi LCD monitor. Where in the photo is the "ergonomically designed" radio that fits in carry-on luggage? K3BU
As Carl points out, the DRM transmissions sound extremely good coming from the RX-340. Carl's software makes DRM interfacing into the RX-340 a snap. With one "right click" of the mouse, all RX-340 re
"So much for "astonishing, unparalleled, ultimate" and other unabashed Icom marketing hype about the 7800." This information may have previously been presented here by others, but W8JI's testing of t
6+ I've heard the issue of the noisy reed relay before and I've come to the conclusion that some TT reed relays are significantly louder than others (perhaps due to differences across OEMs). When I
This is essentially correct. However, there are some differences between the two radios: 1) If I'm not mistaken, the Omni Six (and all factory upgrade versions 1-3) use a crystal oven for the refere
I'm a bit confused over the data as presented in Sherwood's chart: http://www.sherweng.com/presentation.html For example, he shows the Orion with only the 20 kHz roofing filter at 96dB/79dB (20 kHz a