My Omni VI Mod3 has all of the filter slots filled and upon inspection I found that there is not a 217 filter amongst the bunch. I have been on the searchable archives looking for a possible Inrad fi
Still cannot get the serial connection to work. Looking through the manual, I can find no mention and the circuit board descriptions of what circuit board does the interfacing with the serial cable?
Ordinary communications software is much happier if on the 25 pin computer end that pin 4 is connected to 5 (RTS/CTS hardware handshake), TT does not use rts/cts....you might be thinking of Kenwood
DEVICE="parport0" I tried editing DEVICE to ttyS0, the serial port that handles the Orion's serial cable, but this had no apparent effect on Xlog's keyer behavior. Your answer is right there in fron
Excellent presentation, very well written and easy to follow. Your efforts are to be commended. I've used the interface you described for the last 8-9 years. Never a problem. Hams continue to amaze m
First question: For PSK31. how are your guys hooked it?? I made a quick jumper from the line out to my PC line it. seems to work, but the level seems a bit low, but then again I onle used it for lik
I've tried different baud rates and that doesn't seem to make a difference either. I am using a generic USB interface cable that works fine on the Icom. Anybody have any experience with this? Any hel
By the Matrix, are you referring to the option menu setup? I'm not quite sure what you mean. Thanks, Al Its the 3rd item in the menu ....1st is the baud rate...2nd is the hex address...3rd is the ma
Douglas, it makes absolutely no sense to post a digest of the recent messsages. All you are doing is wasting bandwidth. Think before you hit the reply button, we have all seen and read the digest you
On the B- side of the HV is a diode D16 according to the schematic in the metering circuit. Its a 1N4007, make sure it isn't open. I will do that. You need to measure this for forward/reverse resist
You need to measure this for forward/reverse resistance, not continuity. This diode acts as a fuse to protect the metering circuit. With no drive applied, you should see no grid current. Bingo! D16
Excuse me if this is somewhat off-topic, but I've been following the 811 amp discussion with much interest and have a related question: I'm currently doing some work my pair of 813's and was thinking
I did that once.....after $23,000 worth of fire damage from a direct lightning strike that followed the open wire feeder into the house. Be careful and take precautions. 73 Ed W3NR
Ed W3NR Except that shouldn't affect transmitter output. But its a good thing to check first when receive only is down. 73, Jerry, K0CQ Also double check the RCA jumper plug. Ed W3NR