Bought this used from an estate sale in 2014. Worked great for 3 yrs. Then a tube short blew a fuse. Replaced both finals and all was well until a few months ago. The amp worked well for a few transm
Thanks for the suggestions guys. Looking like its a tube issue. I will pass that along to the tech wrking on the amp and see what he finds. Bob Sent from Mail for Windows 10 _________________________
I recommend Malcolm Technical Support - Scott Malcolm - Toledo, WA - (ICOM & Kenwood Service) mts@toledotel.com Used Scott a couple years ago on my balky TS-50 with multiple problems that nobody want
1. I periodically hear an occasional soft "tick" coming from the amplifier during a key down tune up procedure in my Centurion. Assume theyre due to to gas build up in the tunes, discharging? Any ide
This may or may not help, but here's my story. My 23 yo Centurion worked like a charm for 5 years after I bought it used, 10 yrs ago. Then one day the grid started going negative. I had a local tech
My Vectronics DL2500 fan cooled DL seems very stable when tuning up on 160-6m. What kind of dummy load? An off the wall idea, but when the "dummy load gets very warm", is it still 50 ohms - or is the
What you describe sure sounds like a relay problem to me. Although I dont have a Hercules II amp, I do have the same problem with my 20m 2-el vertical phased array. When I go to rx, sigs are sometime
My 238C antenna switch has seemingly gone bonkers. I connect one coax(antenna) to any of the four antenna connectors on the rear of the unit and when I switch from antenna 1 to 2 to 3 to 4, I get the
Who are some recommended repair service providers for TenTec amplifiers ( such as the Centurion amplifier?) Thanks. --From: "Mike Bryce" The ten tec company along with the service department is long