Did you do the firmware upgrade as well? I ran the new GUI with the old firmware and it seems to be OK. Dave, VE1ADH ______________________________________________________________________ Post your f
If it has a built in audio spectrum display a "Spot" is not needed. Dave, VE1ADH ______________________________________________________________________ Post your free ad now! http://personals.yahoo.c
Why not set up a website and put it there? There are lots places that you can set one up for free. I have one on qsl.net <http://www.qsl.net/ve1adh> check it out. Dave, VE1ADH _______________________
My friend Fred ,VE1PBX had a problem with his Paragon shutting down on overcurrent even in receive. The finals were drawing the current but they were not defective, they were turned fully on. The bas
Yes, it was where the wire was in a tight bend. I don't think that was the original cause though. There were four or five turns and the other turns were not damaged. I think the wire had a small hole
My Gap Titan survived hurricane Juan which hit here with 140 Kph winds with gusts to 160 Kph (100 mph). It is guyed with the gap dacron guys. Last winter it came down when loaded with several inchs o
My Yahoo email account dumped this message in my Bulk folder as possible SPAM. I mark it as not SPAM but I can't see why it picked this message out of many similar ones. Dave, VE1ADH ________________
I don't know what the big deal is, just an oscillator and SWR meter. I repaired one that had been damaged by reverse polarity by just replacing all the semiconductors. One chip and a half-dozen FET's
I'm not saying it was easy to fix. What I meant was I didn't see any circuitry in there that would be worth making a big deal about keeping it secret. It took me a long time to fix it. I gave up a co
I suspect that the Tentec grease has high viscosity like the viscose fluid we used to use in viscose damped tone arms on turntables. Dave, VE1ADH _____________________________________________________
My XYL and I had planned a trip this year that would have put us in the area so I could attend the Hamfest. Unfortunately she has to undergo surgery and follow up treatment for breast cancer, so the
A friend who was taught CW as a boy sailor in the Royal Navy told me they were taught to send "BEST BENT WIRE / G" to develop good rhythm with a hand key. Dave, VE1ADH _______________________________
A friend of mine sprayed the PTO in his OMNI C with WD40. I worked great for awhile and then quit altogether. When he brought it to me I took it apart and found it was full of fuzzy green stuff that
There are folks out there that rub WD40 on their bodies for arthritis. It did attack the plastic. The PTO by the way (which was replaced with a used spare) ended up in my junk box. I have used parts
Yep! it's still working. -- Blky4u@wmconnect.com wrote: > test ______________________________________________________________________ Post your free ad now! http://personals.yahoo.ca
I have tried all the CW software that I can find and I think most of it is a waste of time. I learned to copy on paper and when I got up to the fastest speed that I could write it down, I thought usi
A Google search only found CWget, no GetCW. I have CWget and find it to be one of the best but it will only copy really well when the signal is strong and clean. Dave, VE1ADH ________________________
I have re-soldered several Paragon PLL boards and I believe the problem is related to the way temperature changes affects the board. I think the modules which are soldered to the board cause stress o
Have you checked to see if the correct transmit filter has been switched in on the other bands? Also check the receiver bandpass filters. A shorted pin diode could cause low drive in transmit because