Greetings, Perhaps of use for other Orion operators. We have finished developing & testing a small windows program (tested on XP, Vista and 7) which allows very quick adjustment of threshold and RF g
I am investigating how i could make the program available on a server but time is lacking right now. Below the link to yahoo as requested by several. Hope it works... http://f1.grp.yahoofs.com/v1/QIW
Greetings, I have created a public folder and posted the most recent programs and documents created for Orion. At present time it contains the agc macro discussion, orion backup software, serial port
I really like the document as shared and reading through it. Would appreciate your advice on the following rfi experience: recently I build an artificial ground to ensure rfi gets directed somewhere
Besides the standard battery replacement answer I recall similar happening to me a couple of years ago. Turning the vfo knob and relais were clicking for each step. I fail to recall the root cause un
Replacing the logic board is an expensive step. It contains the cpu, both dsp's and most other logic. Despite a high repair bill I dont think ten tec tried to make a business case from this. became o
Hi Petr, Tx relay can be found very near the tx pl connectors. But I doubt that's the issue.you better verify the tx control circuit. Also check through remote control of the tx issue occurs as well.
When transmitting on 10/12 do you see the same current being drawn as applicable for other bands? The pwr / swr detection follows the bandpass filters. If it's not detecting pwr voltage it will just
Hi, Hope someone has experience how to align / adjust the two potentiometers within the pa? I found the pa is unstable and power output fluctuating and expect the potentiometer or any component surro
Most likely RX EQ, passband setting or Rx bandwidth. DSP bandwidth will drive selection of IF filters if configured through menu. Tx and Rx bandwidth work independently. Do you notice difference betw