not so much on a TenTec, but in the basement of our village hall we had a Heathkit wx station controller. The feet had "melted" ( for lack of a better word),,,, also on a large furniture piece, the r
go grab the output of the capsule (R96),,,, before the preamplifier.... disconnect the orange and red lines going to the preamp board, take one to the gnd mic line the shield... take the other mic li
when it comes to industrial product cosmetics....fit and finish ... I have to vote for Icom..... and I think they did not short the funding on any area of development. The K3 does not have the design
AM I THE ONLY ONE TO STILL BE IN THE DARK???? bill _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
Hmmm i do not even wonder who that would have been,,,, :) gud to see ya at the WASHfest bill on a Hill /3 (but not bill hill ) I just rescued the radio from a friend who went out and bought a TS-990.
how many fans / how many amps... are you limited to current capacity of the lm317 , or does that drive some of the transistors???? I've designed a small circuit that will run the a dc fan at high spe
what radio manufacturer charges for update software??? bill ny9h/3 At 07:03 AM 4/10/2014, you wrote: Whatever the name of the future flagship, Ten Tec needs to have a price that allows them to make a
for Jim ... you are DEAD ON .... for Dave on "closing the doors ..".. I know this means keeping the doors open. bill ny9h At 12:16 PM 5/12/2014, you wrote: It sounds to me as if the recent retirement
The RF Concepts name was used when Alpha was purchased. Michael AA6DY has been looking to add product line extensions since he acquired Alpha. TT certainly extends the RFC lineup. RFC was a brand of
actually in Total Control is a guy who is an Amateur, a technoid and an astute businessman And I'd venture that any good ideas are not lost. Only a ham would invest in this vast land. bill ny9h/3 So
and in the macaroni & cheese commercial ... they say " worked ALL the Koreas....." yeah sure,.... esp with THAT rig...... hehehe bill ny9h/3 (a few miles south of Ron ) Besides, according to the book
paypal ok ken ??? bill Power Connector for TenTec Hercules II available: If you have a TenTec Hercules II (Model 420) HF Amplifier, you may want an extra power connector so that you can use any exter
a logic board for an icom 7800 was 900$ ... don't feel too bad At 07:40 PM 8/3/2015, you wrote: Yikes. I'm in the wrong business. Sent from AOL Mobile Mail --Original Message-- From: denton sprague <
does that Include Alpha??? _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
who knows, John Henry may in fact not be representing the ownership, in his forwarding of this funding concept.... bill _______________________________________________ TenTec mailing list TenTec@cont
RX366 Subreceiver (comments posted to the Ten-Tec reflector by John Henry) <http://lists.contesting.com/_tentec/2011-12/msg00013.html>http://lists.contesting.com/_tentec/2011-12/msg00013.html The RX3
Jim, 1 st welcome back.... 2nd Regarding th e charts , would the new synths make any difference ???? 3rd ikz retired !!!!! At 12:42 PM 12/10/2015, you wrote: On Thu,12/10/2015 9:38 AM, Kimberly Elmor
At 10:37 AM 1/5/2016, you wrote: On 1/5/2016 5:32 PM, Peter Frenning [OZ1PIF] wrote: Think Kodak! Tjust because it failed to adapt to a new technology! Actually it was worse than that. Kodak was an e
University of Tennessee ORANGE as in Tennessee Technical Ten Tec Shouldn't it be... Green? (Green is the "in" color these days, after all) 73 [ PS: Yes, I know why it was Orange. I'm just kidding, co
The Icom IC7300 and the Elad FDM-Duo at $1500 and $1150 are both very attractive. elad duo in US is 1149$ 5-8 watts output... bill _______________________________________________ TenTec mailing list