Use the free FLDigi program and connect the audio in and out of your Orion to your sound card. Total cost is zero. It will run AFSK and work like a champ. Carl Moreschi N4PY 58 Hogwood Rd Louisburg,
Comports and serial port are the same thing. Most newer computers don't have serial ports or comports. Instead they have USB ports. When you purchase a USB to serial converter, it makes a serial port
It may work with the Corsair also. You just might have to change out the connectors. Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.com 73, Al Excellent condition, smooth PTO. Pictures
Well they both use a 5.0 to 5.5 frequency. I believe a 243 could easily be made to work with a Corsair. Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.com 73, Al Carl Moreschi N4PY 58
If you happen to have an extra or Jupiter that you are not using, my software has an option to hook up to the 302 through the pegasus or jupiter to just use the 302 knob with a different radio. I hav
GMT and UTC are the same and never change. BST stands for British summer time and that one is one hour ahead of GMT in the summer. Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.com Th
You need a jumper between TXOUT and TXEN to be able to transmit. Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.com When I looked at it on the table where it was placed it looked like
There are situations in digital modes where PBT may need to move a lot. If you were using AFSK on RTTY and wanted to use a 500 hertz filter, you would move PBT a lot from center. Having the extra amo
The battery backed up RAM in the Omni V does not use the battery. It uses a RAM chip with a built in internal battery that cannot be changed. These chips were made many years ago with 10 year life li
It's not the main cpu chip or EPROM. It would be called "battery backed up RAM". I don't have schematics anymore so I can't be more specific on this. In all fairness, back at the time this was being
It's not the EPROM chip. There's no burning. It's a RAM chip with a built in battery. Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.com Clayton N4EV Have you tried calling Ten-Tec for
No, not that one. This is a RAM chip, not the microprocessor with built in EPROM. Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.com Barry N1EU It's not the EPROM chip. There's no burn
If the internal RAM battery fails, all the Omni V memories will be lost at power down. For the Omni V.9, this means you would lose remembering the band stacking register values when you power off. As
I will get back home on Feb 22 and I will test it out then to see if I can reproduce your results. But does this happen if you don't use the frequency scale slider and instead use the band buttons to
Your procedure for calibration does not sound correct. First "Polling" must be off and not used in order to use frequency calibration. Then you find the place where WWV sounds the same on both USB an
I had a 580 Delta for many years. It was an excellent CW radio with the addition of the 500 hertz filter. And it uses the 6.3 mhz filters that the Omni VI uses. Carl Moreschi N4PY 58 Hogwood Rd Louis
Yes, this is very sad. I new Toby from meeting him several times at the Tentec hamfest. He was a great guy and very humble. Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.com 73, Duane
You also need a battery reset. See below. 1) Power off Orion. 2) Power On holding the VFO B LCK button. 3) Continue holding LCK button until the radio says "Battery Failure". 4) Power off Orion. 5) P
The 40 meter band crystal is bad. Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.com On 2/24/2015 12:59 AM, gary mankoff wrote: MY NEW OLD OMNI 5 GOES DEAD ON 40 METERS BOTH RX AND TX
The oscillator in the Orion for the serial port that causes it run to run at 57600 baud may have drifted off frequency just enough to cause an error when lots of data is being sent to it. I do rememb