Search String: Display: Description: Sort:

Results:

References: [ +from:ka2v@roadrunner.com: 4 ]

Total 4 documents matching your query.

1. [TenTec] Ten Tec Omni-D Series B SWR Problem (score: 1)
Author: Mike <ka2v@roadrunner.com>
Date: Fri, 18 Apr 2008 11:58:02 -0400
Hi Guys I Have a Omni-D Series B Transceiver,When I use the radio on 40 and 75 meters SSB.I tune antenna to Flat match,And when I talk the Swr Jumps up to 1.3 and 1.5 reflected,On dead key carrier I
/archives//html/TenTec/2008-04/msg00358.html (7,555 bytes)

2. Re: [TenTec] Ten Tec Omni-D Series B SWR Problem (score: 1)
Author: Mike <ka2v@roadrunner.com>
Date: Fri, 18 Apr 2008 12:38:39 -0400
Well what is puzzling is that it only does it on 40 and 80 meters ssb, 20,15,10 meters works fine...BUT when hooked up into a dummy load(Cantenna),Radio works fine too.I run other radios on my 40 and
/archives//html/TenTec/2008-04/msg00360.html (9,316 bytes)

3. [TenTec] Ten Tec Omni-D Series B Up date (score: 1)
Author: Mike <ka2v@roadrunner.com>
Date: Fri, 18 Apr 2008 14:43:43 -0400
Update Tnx to the Dr Johnson I set the drive down to the 2 position,overall output is 80 to 90 watts out on ssb on 75 meters.Radio works fine.Swr is now stable,But if I go any higher on the drive it
/archives//html/TenTec/2008-04/msg00366.html (6,842 bytes)

4. Re: [TenTec] Omni D series B (score: 1)
Author: Mike <ka2v@roadrunner.com>
Date: Fri, 18 Apr 2008 21:27:27 -0400
Hi Paul Tnx ,I'm finding it out now about the drive setting,I went thru all the diodes on the swr board and pre drive board,Two were bad on the swr board,thus low receive,receive is fine now.i set r2
/archives//html/TenTec/2008-04/msg00375.html (8,575 bytes)

Current List: 1 - 4
Page: [1]
This search system is powered by Namazu