I listened on 20, 40, and 80M while our Maytag Neptune washer and dryer were running and no noise. They are the fancier models with LCD, I think, displays. We have had a Duet Washer for two years now
I hesitate to continue this discussion which has nothing to do with Ten-Tec equipment, but I will add that my 89' US Tower crank-up has taken maybe a dozen direct hits that I am aware of with no appa
Though it's not listed on the contesting.com web site, there's an Orion reflector there too: http://lists.contesting.com/mailman/listinfo/orion Jim N7US Since the Orion is manufactured by Ten-Tec, it
Being a DXer and then contester, that's why I got the old Extra, back in 1968 at the age of 20, along with being able to get a coveted 1X2 call after 25 years. The 25-year requirement was eliminated
I had an OMVI-VI which I had T-T convert to an Option 3. I very much liked the simplicity of the radio, as well as the QSK. I disliked the fact that it didn't shift the center frequency when I wanted
A name search on qrz.com says he's K9YCS, a Tech Plus, with only 12 lookups, so maybe not active. Does PayPal offer any recourse in this situation? Have you tried to call him? SMARTpages.com lists hi
I haven't noticed any distortion on mine. Remember to keep the RF Gain as low as possible...clockwise till you hear band noise. Jim N7US ORION. With signal S9+35 my new Orion distorts audio. Is this
I have the ICE filter because I was too cheap to buy the better one from W3NQN. He had two articles in QST in May and June 1998 if you want to roll your own. If you want to buy a ready-made one, Arra
Look under Filters and Switching Systems on http://www.arraysolutions.com/prod_category.htm. Jim Maybe I am tired, but I could not find the BCI filters. What are they under? Thanks. roll Scout), that
Incidentally, I got the ICE BCB HP filter because of my PROII, not the Orion, which is much better than the Icom. In the daytime, the second harmonic a 50 KW station on 1580 mixes with the fundamenta
Mine sounds just fine with no EQ, using either Heil ProSet Plus or an external speaker (an Icom, SP-20). I typically use 2400 Hz BW to engage the 2400 roofing filter, but wider and narrower BWs sound
Seeing that Jerome was a transplant from the US, I was curious enough to go to qrz.com and then to his web site. It's terrific. Check it out. (Great dog picture too.) http://members.shaw.ca/va7vv/ind
I think John meant to say "CW and RTTY." I like it too. Jim N7US The best roofing filter to get for ssb and rtty is the INRAD 600HZ #762 and put in place of the 1000hz that comes with the radio.. Joh
It looks fine with IE6 and Firefox on two LCD flat panel monitors both running 1280X1024. It's a nice improvement. Jim N7US Not to beat a dead horse to death ..... but the opening page of the Ten-Tec
Stan, Can you tell me why the Studio One is being discontinued? I have a Heil HM-10 mic (with an HC-4 and HC-5) which I think is similar in appearance. Do you know if it uses the same cable as the St
Stan, Do you have any used or demo 302R units for the Orion? Jim N7US Current as of March 17, 2005 The following equipment is available as used equipment direct from Ten-Tec. 30 day warranty, 10 day
Jerry, I assume you mean Hz and not KHz. I like the 10 Hz steps combined with the fast encoder option in the menus. You can always press the MAIN RX or SUB RX buttons for quick excursions. Having sai