I would like to buy your 30 meter module. Please e-mail me! Ivin W9ilf ____________________________________________________________________________________ Do you Yahoo!? Everyone is raving about the
The "Resonate" knob moves up and down and side to side a lot. I think maybe the nut behind the knob needs tightened but I am having trouble finding an allen wrench small enough to loosen the set scre
Thanks for the great information on the allen wrench size and the felt washer to put behind it. I will have to try a hobby store tomorrow. My local hardware didn't have one that small. I enjoy going
I just started having problem with the power out on my Omni D. When I am keying into the rig suddenly the display will go slightly darker than normal and the ALC light doesn't come on. the side tone
My Omni C does the same thing. when I switch in the 500hz filter the s-meter drops off to nothing. It is like it dies unless a pretty stong signal pops it back to life. Otherwise mine works great and
I am looking for a good external VFO for my Omni C. I know they don't get separated from their rigs too often and kind of hard to find. I'm just taking a chance to see if I can find one here. This is
I have been looking at the TenTec 715 speech processor on the Ten Tec web site and now saw a review on it in the latest QST. From what I read it would be very effective on a radio that does not alrea
I had a Ten Tec Scout a couple years ago for a short time but wanted a true QRP rig so I found it a new home. I liked it quite a bit though I thought the modules were a draw back. I also know the cla
I'm following some of the thread of the Omni VII discussion and I see the Corsair II thrown out there. I hear often that it has such a great reciever. I own a Omni C and added a external VFO(thanks t
Jeramy I would think the rigs you mention you would like to trade for all have somewhat a unique look/feel. The Omni C which I have would be similar to a Corsair II, but doesn't look much like one th
The SWR/S Unit meter on my Ten Tec Omni D series C isn't working very well. It seems fine when I first power on the radio. In just a little bit of time it just lays completely down to the left like n
It works both ways when it is working which isn't much. It doesn't move a bit when it isn't either for SWR or S unit. _______________________________________________ TenTec mailing list TenTec@contes
I have a Omni D series C. The 28.5 position on the band switch isn't working. All the rest do and I have used this radio for several years daily. I haven't tried to go to 28.5 in quite a long time
BINGO! Thanks! I have also seen it where the crystal contacts are a little oxidized, and inserting and removing the crystal helped the clean the contacts. I made the fix by following up with a tiny
Nothing that I have heard. I just like to have everything working. I was trying to listen for activity on the date October 10, 2010 as 10/10/10 and hoped to hear something but never did. I did ge
Don, I have been working through that with my Omni D series C. I called Ten Tec early last week and got the recommended PTO rebuild kit suggestion. $35.00 I believe plus shipping. They also sugges
I had a comment while on the CW traffic net 40 meters tonight that my tx was drifting up and down a little while transmitting on my Omni D series C. I could also hear the freq shift in the receiver.
I followed N4LQ's AGC mod of tack soldering a 5.6k ohm resistor across the 100k resistor in R39 on the IF-AGC board. I found it's location by it being right above the IC chip. The mod seems to make
I no longer need the remote VFO model 243. I gave the radio to a good friend. The VFO looks good no scratches on the VFO knob or any noticeable damage except the plastic around the harness has some