Hi, Out of curiosity did you check the voltage getting to the O2? The radios do strange things when the voltage is a bit low. I've wasted quite a bit of time trying different things every time my d
I wonder who else is getting tired hearing about new products when Ten Tec still hasn't finished the simple things on their old products. John Henry told me at the Orlando Hamcation that it was an e
Hi Jerry, I understand your point perfectly well. John Henry told me that adjusting the alignment is very easy...just changing a variable in the FW. If it is that easy then it should be done so the
Hi Rick, The reason why I suspect it hasn't been fixed yet is because it was not fixed in the latest release, which was well after I complained about it. Prior to the last release, there was a probl
I'm hoping for a FIRMWARE update on the simple issues that were found with the last version of the ORION II code. I would rather get that than free shipping on products I have no interest in. Thanks
Hi, I was wondering if anyone noticed that the spectrum display reads correctly on USB but is off a bit for CW and LSB modes. When a signal on USB is tuned in properly, the peak on the display is ri
Hi Jim If the peak were off the same amount for LSB and USB, I would agree with you but the peak seems to be right on the money for USB but is off for LSB and CW modes. As I understand, there is jus
Hi, I was wondering if I am the only one who thinks there is at least one unresolved issue in this latest version of firmware. I'm not talking about things that you'd like to see, but things that ju
Hi, I just downloaded and installed v3.026 and was playing around with it. SAF works pretty well. I had a bit of an issue with it because I use the display sweep and noticed that the signal peak on
Hi, I just wanted to say THANKS!! Not being a "power user", I appreciate the small things like having a centered display. The SAF seems to work well and having made a few contacts with the new cod
Hi Andrew, Have you checked with Ten Tec to see if they can supply you a parts list (bill of materials) that normally accompanies a schematic? If they supply it electronically...like in a spreadshee
I saw the KPA500 at the Orlando Hamfest. Yes, it looks nice. It also looks cheap much like the rest of their equipment. For the kind of money they are getting for their equipment, the mechanical aspe
Jim, When I can pick up a radio and twist it, I call it cheap. Yes, even with the material thickness being what it is on the K-Line, it looks cheap too. Having a felt washer as a method for adjusting
Hi, I was wondering if anyone else noticed that the monitor volume is very low when using the speaker output. It seems fine with headphones, however. I'm also finding that after loading the new firmw