Carl; If it's the same LP Tennadyne I helped a local DX'er put up it was way to big for me! SteppIR is easier to handle. The motors work fine and I believe the military and some DX expeditions are us
I have had this very problem and mentioned it to the TT group. It hasn't happened over the past two months. I don't know what is different in my set-up though?? George
Anyone have their O2, or O1 for that matter working with the SteppIR controller and their computer using a RS232 DB9 Y cable. I called the SteppIR people and they said nada, no, it won't work! The St
Tom; My start up code comes up 3E6 3A04 when I turn on the controller. I would have thought the Fluidmotion would have known this??? I'm going to call them today and ask about this. If I'm correct in
I guess I owe everyone an explanation as to my problem with my Orion2 and my SteppIR control box using the Fluidmotion Y cable communicating with my computer . First let me say that when I received t
I guess I owe everyone an explanation as to my problem with my Orion2 and my SteppIR control box using the Fluidmotion Y cable communicating with my computer . First let me say that when I received t
I was hit with lightening the other day and my O2 to SteppIR control box are no longer on the same page. Normally, when I change the O2's frequency the SteppIR box changes the beam to the same freque
Thanks to all that responded to my O2 DB9 interface dilemma. OK, it appears it's the O2 that's in trouble as it will not do an update. My question is, to eliminate the need to send the radio back to
Carl; No such luck. The tech department said "we do not replace boards rather fix them". So it's off to Ten Tec for the O2 after it's disagreement with Mother Natures fire-works. Of course Mother Nat
Gang; Am I the only one that has a missing pixel in the upper part of my O2's LCD readout. I had it back to Ten Tec and they couldn't "re-create" it??? They are shipping it back without calling me to
Doug; Thanks for the reply. The O2 is on it's way back but I think it's a bad pixel??? I'll update it and try all the things you mentioned when it gets back. George
Over the past few days I've noticed my O2 has been sounding like the audio is coming through a pipe or barrel??? Small but noticeable. I've tried enabling and disable everything. I checked all the me
I know this has been disseminated before but could someone repeat the Air-Pax contact and what model number to order for an Orion2. Although I have had no problem, being safe is good! Thanks. George
I still can't understand why Yeasu and Icom don't use close in filters like the Orion2??? I'll have to wait until the testing is done on this unit in close in 2KHZ dynamic range and where it falls in
My Orion2 finally met it's match. HB9RDE was on 18.112.5 running 50 over and I was trying to copy EL5PM running S8 on 18.115.0, a new one for me. The SteppIR beam was headed 100 degrees from the West
I am still having trouble with my SEND1 memory garbling up my entered call when using SEND1 to send. I've tried to erase and re-enter my call a number of times and still it is intermittently bad. It
I had a problem with my O1 & O2 with the TT 706 mic. Key stuck and RF in the audio. I found that when I pointed the beam right over the shack the problems started. I was able to eliminate almost all