Kevin, the Pegasus has a notch. It works good. I do not use it very much since I spend most of my time on psk31 which uses the computer sound card for the final DSP. Also I use MixW software for Mors
That is why a IF DSP receiver has the potential to be very low noise. The IF DSP receiver does not need narrow ringing filters or complex circuits to get passband tuning. There is no noise introduced
Why would they drop the Centurion? It uses the easy to buy 3-500Z's. The Titan II uses the hard to get 4CX1600B. It would be easy to put the Centurion in a black box. Jim W7ANF
The AM stations do not always follow the rules. The two 50 kW AM BC stations near me sometimes run all night at full power. Neither is a clear channel station. I checked and they should drop their po
My Astron 35M has plenty of power to destroy my Pegasus finals even with the current limit. I now have a 20 Amp circuit breaker in series with my Pegasus. I do not plan to see if the circuit breaker
I have heated up both N and BNC connectors running high VSWR at powers as low as 200 Watts. The UHF connector does have a larger center pin. I melted a RG-8 cable with 200 Watts at 10:1 VSWR. I do no
I have used the VOX on my pegasus for psk31 and it works. You have to set it up carefully. I use N4PY software to control the pegasus and MixW for psk31. The VOX works so good that SOX is not necessa
Stuart, I have a Pegasus and I never noticed the DSP tones. I installed the free firmware fix that I downloaded over the internet. I noticed the improvement. The tones were gone. Having a easy fix fo
The main thing the RX-340 has is the high dynamic range front end. There is an IF output that has no AGC and little filtering to be used by an external DSP processor. I hope the Orion would at least
I have three 572B's in my Centaur and I can get 400 Watts out on the 10 meter band only by tuning it to maximum out on both the load and tune capacitors. The plate current is 500 mA at 1500 Volts. To
Ronnie, I am sending this direct also since I have trouble posting on the Ten Tec list. My answers are below. Jim W7ANF I use N4PY control software and MixW sound card and logging software. MixW supp