Tim, they work great. The power supply will not put out any more power. For SSB you can put out more power since the average current is lower than CW or RTTY. I got a matched set of three 572B's for
Before I had a interface, I used VOX on my Pegasus. You need to adjust the VOX and all the delays until it works smoothly. I use the accessory input and output so there is one cable connecting my Peg
Vince, it is possible to do psk31 without any interface. You do need to adjust the soundcard output or the audio input so that it does not overdrive the Pegasus. That is hard since the Pegasus does n
Jeff, you could put an attenuation network in the line from the Pegasus. My soundcard has a line input which can handle the output of my Pegasus. Jim W7ANF just to tried
I have a Pegasus and I receive weak 10 M signals all the time. I did turn up the IF gain on my Pegasus since I use 10 M more than any other band when it is open. There is more noise from my computer
I do not know. The Jupiter is almost the same as the the Pegasus. The Jupiter has an improved pre-amp like the RX-350, but all the rest should be the same. Be warned that with the pot turned up you n
The N4PY software controls the Jupiter with the front panel on. Logging and contest software will also control the Jupiter. I think MixW logging and contest software will control the Jupiter. http://
There are verticals that do not need radials. I use a GAP Titan. It works 80M to 10M with no radials. I use my wire on 160M and 80M. The GAP Titan has a very narrow bandwidth on 80M. http://www.gapan
Both the the GAP and Force 12 are center feed vertical dipoles and there is no way to attach a ground plane. They both work better over water or a very low loss ground. All antennas put out more powe
Both Digipan and WinPSKse work with the Pegasus using either the Ten Tec software or the N4PY software. You can use VOX to key the Pegasus or a seperate serial port to key the Pegasus. I use a sepera
I use those paddles also. I double sticky them to the top of my portable rig. Jim W7ANF -- Original Message -- From: "KZ2G" <kz2g@optonline.net> To: "H. M. Nadel" <hmnadel@optonline.net>; <hfpack@yah
I will try using a USB to serial on my Pegasus. My RX-320 is running on a USB to serial using N4PY software. I use a real serial port for my Pegasus now. Jim W7ANF
The Jupiter has the same pre-amp as the RX-350. So there are a few differences between the Pegasus and the Jupiter. I am happy with my Pegasus. If the Jupiter was available in 1999 I would have a Jup
The Pegasus and Jupiter notch is a multiple automatic notchs. It works ok for SSB. It works poor for CW. It does not work for digital modes. It finds the carriers and notches them out. The notch is i