Got lots of response for which I most appreciate. I tried all the obvious things. Processor reset, etc. When this occurred I was sitting here listening to Dodger baseball on 1150 AM... I had worked s
I downloaded the upgrade from the site, BUT.. the latest "ruf" file contained is the 1.12 version. Looks like someone may have forgot to include the 1.14 version.. OR.. of course I may be missing som
I just had a short chat with the guys at Ten-Tec regarding problems with the new 1.14 release. This is what I was told. While there may be other issues, the fact that you get reduced power out when y
Yes.. that would seem to be the case all right. I certainly have no issue with the "Tune" function reducing power. It's probably a good innovation.. But.. your right.. it should not be a "sticky" fun
After owning my Jupiter for several months, I got around to trying it on AM yesterday. The reports were that my audio was very distorted... perhaps due to over-modulation. In the prior firmware relea
I have a problem with the two firmware upgrades that were released in the last couple of days. I like to use the N4PY software when I run PSK31 and have been unable to control the output with the N4P
First.. thanks to those of you who provided me with the 1.09 firmware, so that I could go back to that firmware level. Here is the problem I am experiencing with either the 1.10 or 1.11 firmware rele
Just to follow up here.. No need to try to replicate the problem as I asked in my last email. I just got off the telephone with Gary at TT to report the results of my trying the TT software instead o
I just received a copy (perhaps an advance copy) and was asked to check things out. All seems well now with my Jupiter and the N4PY software and I have reported that back. I am not sure what the post
Well I should have dug a little deeper with the advance copy of the 1.12 firmware for the Jupiter I received earlier. Yes.. the problem interfacing with the N4PY software is resolved.. But that has b
I have been monitoring the Jupiter power thread and can only comment that I have NOT seen that at all. What I do see when I use my Jupiter for PSK31 is a very non-linear increase in power out as I in
I have not noticed this until today, because I run a lot of PSK31 where not much power is ever needed. However.. with RF power maxed out and the "Tune" button depressed, I get the following readings
I thought I would try AM mode on my Jupiter (1.09 firmware) for the first time this afternoon. I tuned to 29.000 and connected to my dummy load. I then hit the "Tune" button which is supposed to acti
I have a question or two with anyone using the Jupiter with a Heil BM-10 or Goldline. I have only had the rig for a couple of days but it seems that it takes relatively more mic gain with this rig to
I took delivery on my new Jupiter last Friday and have been able to make very few contacts because my perception from here in So. CA is that conditions are BAD and have been for several days. I would
I took delivery on my new Jupiter last Friday and have been able to make very few contacts because my perception from here in So. CA is that conditions are BAD and have been for several days. I would
After numerous on-the- air tests and self-monitoring, I have decided that the Jupiter to Heil HM-10/HC-5 is a shaky marriage at best... that with the internal mic gain control max'd out, etc. Conside
This reflector is GREAT. My thanks to Clark, who was very quick on the draw.. and others who were about to stick a ruler on their 705 Regards.. Bill, W6WLB