Search String: Display: Description: Sort:

Results:

References: [ +from:RMcGraw@BLomand.Net: 2551 ]

Total 2551 documents matching your query.

101. Re: [TenTec] Ten Tec Mic (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Wed, 5 Feb 2020 18:41:03 -0600
While correct in that the older radios used Hi Z mikes, it is perfectly normal  and acceptable technically to use a Lo Z mike into a Hi Z input.  The only drawback is a Lo Z mike may appear to have l
/archives//html/TenTec/2020-02/msg00024.html (9,039 bytes)

102. Re: [TenTec] FW: Fan Kit (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Wed, 5 Feb 2020 20:20:41 -0600
$77 for a fan kit????? Ouch! Bob, K4TAX Sent from my iPhone
/archives//html/TenTec/2020-02/msg00025.html (7,856 bytes)

103. Re: [TenTec] TEN TEC (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Thu, 6 Feb 2020 13:04:56 -0600
Why not send a message to them and ask that question? Bob, K4TAX Sent from my iPhone
/archives//html/TenTec/2020-02/msg00028.html (8,009 bytes)

104. Re: [TenTec] TEN TEC (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Thu, 6 Feb 2020 13:13:52 -0600
I just called and they answered the phone after the 4th ring. Bob, K4TAX Sent from my iPhone
/archives//html/TenTec/2020-02/msg00031.html (9,345 bytes)

105. Re: [TenTec] Triton IV Model 540 (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Mon, 10 Feb 2020 14:07:55 -0600
Go to any fabric store or even Walmart and get some stretch cord about the same size.  Simple enough to replace.  Just get some about the same size.  It isn't critical. 73 Bob, K4TAX Thanks. Rich Wag
/archives//html/TenTec/2020-02/msg00038.html (7,582 bytes)

106. Re: [TenTec] A Scout repair solution for the archive (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Mon, 10 Feb 2020 21:40:08 -0600
Good troubleshooting job! Thanks for sharing your findings and solution. 73 Bob, K4TAX Sent from my iPhone
/archives//html/TenTec/2020-02/msg00041.html (8,662 bytes)

107. Re: [TenTec] Omni VI Plus problem, help requested? (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Thu, 13 Feb 2020 15:01:43 -0600
Check power connections on the rear. Normal problem with the Molex type connectors is the contacts loosen and heat with increased current. Needle nose pliers carefully used will tighten them. But the
/archives//html/TenTec/2020-02/msg00047.html (10,213 bytes)

108. Re: [TenTec] Fan kit for O2 (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Fri, 14 Feb 2020 11:33:28 -0600
Peter et al: I picked up a 12 VDC fan from a local hamfest, or perhaps on-line.   Choose one about the size of the heat sink or a bit smaller.     For attaching the fan to the heat sink,  I used the
/archives//html/TenTec/2020-02/msg00051.html (8,138 bytes)

109. Re: [TenTec] FT8 setup with Omni 7 (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Mon, 17 Feb 2020 14:04:29 -0600
Make sure the audio level is adequate from the computer to the Signalink to key the Signalink.  This is controlled by the SPKR ICON on the computer.  Should be 30 to 50.     If the red LED on the Sig
/archives//html/TenTec/2020-02/msg00058.html (8,499 bytes)

110. Re: [TenTec] files section (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Sun, 23 Feb 2020 17:06:11 -0600
There is a FILES section for several Tentec models on Groups.IO. What specifically do you need? Bob, K4TAX Sent from my iPhone
/archives//html/TenTec/2020-02/msg00066.html (7,631 bytes)

111. [TenTec] files section (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Sun, 23 Feb 2020 19:17:34 -0600
The Omni VII manual can be found as a PDF at this link: http://www.tentec.com/wp-content/uploads/2016/05/tt_588_manual_v2.0.pdf The schematics are at the same link but a bit further down the page, st
/archives//html/TenTec/2020-02/msg00067.html (9,490 bytes)

112. Re: [TenTec] Long shot! TT 239 panel needed (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Mon, 24 Feb 2020 09:13:31 -0600
Looking for a panel, although a discontinued product, I suggest contacting SERVICE@TENTEC.COM to inquire if one might just be available. I would consider making one from a blank panel.    Access to a
/archives//html/TenTec/2020-02/msg00070.html (9,110 bytes)

113. Re: [TenTec] Eagle & Heath SB-200 Amp (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Tue, 25 Feb 2020 10:39:31 -0600
WOAH!    STOP!    If the amp has not been modified for the KEY circuit, it has 120 volts on the center pin of the RCA connector.   If this is connected to the Eagle it will immediately destroy the Ea
/archives//html/TenTec/2020-02/msg00078.html (10,117 bytes)

114. Re: [TenTec] Eagle and Heath SB-200 Amp (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Tue, 25 Feb 2020 10:54:03 -0600
OK, accepting the fact regarding the keying interface, be safe and CHECK FIRST. With the amp not connected to the Eagle, turn the amp on, then measure the voltage between the center pin of the amplif
/archives//html/TenTec/2020-02/msg00080.html (8,493 bytes)

115. Re: [TenTec] Eagle and Heath SB-200 Amp (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Tue, 25 Feb 2020 11:07:17 -0600
Oh I hate those words!    "and I assume.......".   Doing that is a sure way to damage a radio or other equipment, thus requiring likely extensive/expensive repairs. I find many hams give random, and
/archives//html/TenTec/2020-02/msg00081.html (8,128 bytes)

116. Re: [TenTec] Eagle & Heath SB-200 Amp (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Tue, 25 Feb 2020 11:38:19 -0600
Not only that, but be sure your antenna will handle the power as well. If you employ a balun in the system, this another item which is often a weak point in the system.  I prefer baluns that are rate
/archives//html/TenTec/2020-02/msg00083.html (10,978 bytes)

117. [TenTec] Tentec Nets and Schedules (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Tue, 25 Feb 2020 16:02:03 -0600
Please feel free to join any or all of the following: Schedule of the 5 weekly TEN-TEC Nets in the order of which they begin: 80 Meter SSB net starts each Saturday at: EARLY EDITION of the Net cranki
/archives//html/TenTec/2020-02/msg00089.html (8,458 bytes)

118. Re: [TenTec] Eagle & Heath SB-200 Amp (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Tue, 25 Feb 2020 17:14:51 -0600
Yes there are various ways to safety deal with keying issue. However if one is not absolutely sure of what they are doing and assured of the results, then it may become a science project with unknown
/archives//html/TenTec/2020-02/msg00094.html (13,223 bytes)

119. Re: [TenTec] knobs (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Sat, 29 Feb 2020 13:14:15 -0600
Have you inquired at SERVICE@TENTEC.COM? 73 Bob, K4TAX Sent from Mail for Windows 10 _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.
/archives//html/TenTec/2020-02/msg00105.html (7,110 bytes)

120. Re: [TenTec] Cleaning (score: 1)
Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
Date: Wed, 1 Jan 2020 10:44:42 -0600
A soft artist brush and Windex. 73 Bob, K4TAX Thanks, 73s, Rick WO8L Sent from my iPhone _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contest
/archives//html/TenTec/2020-01/msg00001.html (8,333 bytes)

Current List: 101 - 120
Page: [1] [2] [3] [4] [5] [6] [7] [8] [9] [10] [11] [12] [13] [14] [15] [16] [17] [18] [19] [20]
This search system is powered by Namazu