if you call up the folks and say tentec airpax , they know which ones we order.. Go to http://www.pocosales.com/ and place an order. The ordering details for the 20 amp instant type are: Airpax T11-1
Original manual en route from seller of radio. At no time did my email infer that I was looking for a free or bootleg copy of what I assume to be a copywrite document. My morals do not vary; I am a l
http://www.rfsquared.com/ any idea what this changes.. I was having problems with the monitor functions on ssb when using stored memories causing self feedback and loud squeals when monitor was on ev
http://www.rfsquared.com/ any idea what this changes.. I was having problems with the monitor functions on ssb when using stored memories causing self feedback and loud squeals when monitor was on ev
To the esteemed group.... For about the same money you can choose a used Ten Tec Orion (original one) or an Icom 756 ProIII. Any thoughts as to which to choose ? Regards Ed W3ETC == well ,I had a 756
can some one point me to where I can get a copy of 1.371 and perhaps even the original code set for the Orion, I bought mine later and started with 1.372. I would like to have a copy of both for my a
George, If your problem isn't solved, my "simple mind" may see a simpler solution. I would wire a stereo plug on the mono phones as it shows in the manual and eliminate the extra box and cord. My RF
The entire history of firmware is available at _http://n5na.net/orion/ _ (http://n5na.net/orion/) K4ia "Buck" Fredericksburg, Virginia USA thanks tom N6AJR ___________________________________________
What's a PR40? a very expensive mic fro Bob Heil.. _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
a funny story we used to have a cheep Conair brand telephone. it had a rin tone like a high pitched bird chirp. I never could hear it ring. at one time I was standing in front of the phone and it sta
I just worked ON4UN in the contest at 3736/3854. Simply spectacular audio and John confirmed he is using Orion. WOW ! what beautiful TX sound. Al W4ABW _______________________________________________
please, give this a break, it is between the buyer and seller.. tom N6AJR == In a message dated 3/8/2006 5:52:24 A.M. Pacific Standard Time, mike_n4nt@charter.net writes: To clarify things. I did not
I suppose if you figure tube rigs have been around many years longer than solid state rig, they probably are cleaner due to less exposure to dirt , dust and smoke. :) in truth it is just dependent on
I have been following this thread for a while now and I must say that even thought I did own a 756, and still own a 746 pro and the Orion, among others I think I have actually turned the sweep on may
as an aside to the comments below here is my take. Orion running 1.732, alpha 87a, 3 ele steppir or gap voyager, my basic setup . I also have a 5btv, ma5b alpha delta 160-20 sloper and other antennas
I think you both miss the point, about 10 messages back one of you stated the it sounds like it works , eve though it was caused by both the signal and noise dropping causing it to sound like a bette
I use good external speakers on all my rigs. I have a lot of hearing loss form stuff overs the years so I find that 7 or 11 inch metal cased rca or realistic speakers or even those old stereo speaker
Regarding the using of Hi-Fi speaker on the radios, keep in mind that these speakers are designed to have extended frequency response way beyond the needed and capable response of the radio. And in t
Bottom line is , how does it sound, not how does it look on the monitor,. Some where we loose sight of the fact this is a radio, primarily designed for the ham bands and SWL and should be good on cw
keep trying to get off this list, but somehow I still get emails. I have unsubscribed, and when I go to the site it says I am not a member, yet I still get emails. Can someone please fix this for me?