- 1. [Trlog] Keyboard command to switch vfos (score: 1)
- Author: "Bob Tellefsen" <n6wg@comcast.net>
- Date: Wed, 13 Oct 2004 14:41:28 -0700
- I'm working on programming a couple of buttons to allow keyboard switching from vfo A to B and back again. George Fremin pointed me to section 5.3 in the manual, which shows how, sort of, but I need
- /archives//html/TRLog/2004-10/msg00037.html (7,122 bytes)
- 2. Re: [Trlog] Keyboard command to switch vfos (score: 1)
- Author: Ken Beals <k6mr@pacbell.net>
- Date: Wed, 13 Oct 2004 14:53:56 -0700 (PDT)
- Bob: Go to the Elecraft site and download the "KIO2 Programmer's Manual". It has all the codes for the K2. Looks like an FR0 (that's a zero) will set VFO A receive, FR1 sets VFO B receive. This comma
- /archives//html/TRLog/2004-10/msg00038.html (7,740 bytes)
- 3. Re: [Trlog] Keyboard command to switch vfos (score: 1)
- Author: Ronald Rossi <kk1l@intergate.com>
- Date: Wed, 13 Oct 2004 23:00:33 -0400
- You need a semi-colon at the end of each command for the Kenwoods. It is likely the same for Elecraft. FR0; = VFO A Rx FR1; = VFO B Rx FT0; = VFO A Tx FT1; = VFO B Tx Ken Beals wrote: Bob: Go to the
- /archives//html/TRLog/2004-10/msg00040.html (9,085 bytes)
- 4. Re: [Trlog] Keyboard command to switch vfos (score: 1)
- Author: VR2BrettGraham <vr2bg@harts.org.hk>
- Date: Thu, 14 Oct 2004 22:29:29 +0000
- N6WG asked: I'm working on programming a couple of buttons to allow keyboard switching from vfo A to B and back again. George Fremin pointed me to section 5.3 in the manual, which shows how, sort of,
- /archives//html/TRLog/2004-10/msg00042.html (7,695 bytes)
This search system is powered by
Namazu