Mail Archive Search: <+from:mike@rfiservices.info>

Results:

References: [ +from:mike@rfiservices.info: 11 ]

Total 11 documents matching your query.

1. [RFI] Help with those S7 - S9 noise levels (score: 1): Author: mike@rfiservices.info (Mike @ RFI Services); Date: Tue, 14 Jan 2003 18:26:29 -0500; If you would like assistance with inside noise sources check out rfiservices.info. There is an information sheet available that will help you locate up to 80% of the noise sources associated with RFI; /archives//html/RFI/2003-01/msg00023.html (7,278 bytes)
2. [RFI] High Pressure Sodium Street Light (score: 1): Author: mike@rfiservices.info (Mike @ RFI Services); Date: Tue, 14 Jan 2003 19:02:01 -0500; HPS Lights aren't normally detectable at 130 mhz. However, if you think it is the source of your RFI, triangulate. Back away from the light post until the RFI is detectable. Set your sensitivity to m; /archives//html/RFI/2003-01/msg00025.html (7,967 bytes)
3. [RFI] "Jason Hissong" RFI not street lights (score: 1): Author: mike@rfiservices.info (Mike @ RFI Services); Date: Tue, 14 Jan 2003 19:16:04 -0500; Jason's web site recording isn't a street light. You have a classic arcing source. Most likely from power lines. From the picture in Jason's web site, there is an obvious potential for a problem. Loo; /archives//html/RFI/2003-01/msg00026.html (7,976 bytes)
4. [RFI] Electrical Safety (score: 1): Author: mike@rfiservices.info (Mike @ RFI Services); Date: Tue, 14 Jan 2003 19:50:14 -0500; The difference in potential caused by removing one of your utility grounds has the potential to end a life. Believe me it happens. Sometimes electrical safety codes seem simple and ridiculous. A lot; /archives//html/RFI/2003-01/msg00027.html (7,322 bytes)
5. [RFI] Inside sources (score: 1): Author: mike@rfiservices.info (Mike @ RFI Services); Date: Thu, 16 Jan 2003 20:48:07 -0500; Wiley is correct. This is a rarity. However, Wiley did a good job of explaining this. This can occur when it is an internal source. The internal wiring is an antenna. When you turn off the breaker of; /archives//html/RFI/2003-01/msg00040.html (7,738 bytes)
6. [RFI] More than RFI Issues! (score: 1): Author: mike@rfiservices.info (Mike @ RFI Services); Date: Tue, 3 Dec 2002 19:35:25 -0500; Sounds like someone needs an anger management forum. - - - - Mike Martin RFI Services 6469 Old Solomons Island RD Tracy's Landing MD 20779 301-855-5961 Tel 410-741-5153 Fax 21*29180 Nextel mike@rfise; /archives//html/RFI/2002-12/msg00023.html (6,470 bytes)
7. [RFI] simple attenuator (score: 1): Author: mike@rfiservices.info (Mike @ RFI Services); Date: Wed, 18 Dec 2002 16:36:51 -0500; A very simple and cheap variable attenuator is available at radio shack. They are connected via F connectors. Because your just receiving the F connectors won't be important at vhf and below. If one; /archives//html/RFI/2002-12/msg00041.html (7,511 bytes)
8. [RFI] Wiley has Power line noise (score: 1): Author: mike@rfiservices.info (Mike @ RFI Services); Date: Sat, 30 Nov 2002 23:03:20 -0500; This has been a busy day. It sure sounds like sparking to me. Most likely the power line kind. I think it would be safe to assume the source is associated with power line equipment. Best wishes Wiley; /archives//html/RFI/2002-11/msg00000.html (6,689 bytes)
9. [RFI] Not cable tv leakage! (score: 1): Author: mike@rfiservices.info (Mike @ RFI Services); Date: Sat, 30 Nov 2002 23:06:46 -0500; It would be hard to mistake DSL and/or cable TV leakage for power line noise. Your file is definitely a 60hz spark and most likely associated with power line hardware. Mike Martin RFI Services 6469 O; /archives//html/RFI/2002-11/msg00001.html (6,134 bytes)
10. [RFI] I recieve calls from both sides. (score: 1): Author: mike@rfiservices.info (Mike @ RFI Services); Date: Thu, 28 Nov 2002 10:52:19 -0500; Hi Eddy, I receive calls from both the FCC and the power companies. I'm assuming you have other questions related to these contacts. I'd be happy to share any general info I have with you and or the; /archives//html/RFI/2002-11/msg00043.html (6,748 bytes)
11. [RFI] Power line noise is just a nuiscence?? (score: 1): Author: mike@rfiservices.info (Mike @ RFI Services); Date: Sat, 30 Nov 2002 11:40:18 -0500; Over the past several months I've received several letters from power company employees as well as ham radio operators asking about the justification for a full time RFI investigator. When I hear thi; /archives//html/RFI/2002-11/msg00046.html (10,194 bytes)

Current List: 1 - 11
Page: [1]