- 1. Re: [RFI] ARRL to FCC... (score: 1)
- Author: "Bruce" <k1fz@myfairpoint.net>
- Date: Fri, 21 Mar 2014 23:05:37 -0400
- Good point Dale. Does a JR operator plug the hole in his marble bag, then pick up the ones that escaped, or does he let the bag empty out and then start picking them up ?. Hmmm Reducing the size of g
- /archives//html/RFI/2014-03/msg00071.html (9,186 bytes)
- 2. Re: [RFI] Noise cancellers.... (score: 1)
- Author: "Bruce" <k1fz@myfairpoint.net>
- Date: Mon, 24 Mar 2014 00:46:45 -0400
- Power companies ground most poles, and the common wires go back to earth at various points. Most loop antennas do not "share" a connection to ground as part of their tuning. This ground disconnect he
- /archives//html/RFI/2014-03/msg00140.html (8,705 bytes)
- 3. Re: [RFI] More on "my" noise. (score: 1)
- Author: "k1fz" <k1fz@myfairpoint.net>
- Date: Mon, 28 Apr 2014 14:59:37 -0400
- The wide width is most likely coming from receiver overload, or a noise blanker that somehow elecrically is still on. 73 Bruce-K1FZ www.qsl.net/k1fz/beveragenotes.html Yep, heard in Portland on 4386
- /archives//html/RFI/2014-04/msg00225.html (15,920 bytes)
- 4. Re: [RFI] w7ekb & ground rods (score: 1)
- Author: "K1FZ-Bruce" <k1fz@myfairpoint.net>
- Date: Thu, 15 Jan 2015 15:18:58 -0500
- The power company installed a remote reading sensor on my meter. I noticed a noise increase. Took a portable receiver into the basement and found noise along a very old house ground to my water line
- /archives//html/RFI/2015-01/msg00113.html (11,156 bytes)
- 5. Re: [RFI] w7ekb & ground rods (score: 1)
- Author: "K1FZ-Bruce" <k1fz@myfairpoint.net>
- Date: Sun, 18 Jan 2015 11:20:00 -0500
- I use thick wall 3/4 inch copper pipe from local hardware stores. Beating the ground end of a segment into a point with a hammer, makes the insertion into the ground easier. It can skid around smal
- /archives//html/RFI/2015-01/msg00149.html (9,988 bytes)
- 6. Re: [RFI] w7ekb & ground rods (score: 1)
- Author: "K1FZ-Bruce" <k1fz@myfairpoint.net>
- Date: Sun, 18 Jan 2015 13:28:38 -0500
- The water idea is good on the near ground rod, but not so easy on the far end of a very long Beverage antenna. Earlier in the discussion, (note lower in this posting) it was noted that much of the
- /archives//html/RFI/2015-01/msg00151.html (11,454 bytes)
- 7. Re: [RFI] w7ekb & ground rods (score: 1)
- Author: "K1FZ-Bruce" <k1fz@myfairpoint.net>
- Date: Sun, 18 Jan 2015 13:56:49 -0500
- John, Very good ideas. About the water method being better than the impact driver wonder if anyone has had a second try at this. It came to mind that if the water method stalled out, it may have
- /archives//html/RFI/2015-01/msg00152.html (9,466 bytes)
- 8. Re: [RFI] w7ekb & ground rods (score: 1)
- Author: "K1FZ-Bruce" <k1fz@myfairpoint.net>
- Date: Mon, 19 Jan 2015 10:11:43 -0500
- A lot depends upon location. Multiple Short 3 foot rods here in Maine, would not be effective some years. The ground in winter can freeze down to 4 feet. Frozen earth is close to an insulator.
- /archives//html/RFI/2015-01/msg00156.html (15,384 bytes)
- 9. [RFI] Fwd: Re: Topband: Auto quieting (score: 1)
- Author: "K1FZ-Bruce" <k1fz@myfairpoint.net>
- Date: Sat, 03 Oct 2015 23:06:54 -0400
- - Hi Mike, Your fuel pump may be a solenoid type, not a small motor whine type. Please see the attached site. www.jeeppatriot.com ... Jeep Patriot Engine and Drivetrain 73 Bruce-k1fz www.qsl.n
- /archives//html/RFI/2015-10/msg00002.html (7,952 bytes)
This search system is powered by
Namazu