Same problem here but with an AP1000 with indoor amp running Version 4.43 karlnet I restart the amp traffic comes back. Very frustrating. Randy Hi All, Just wondering if anyone else is experiencing a
If you have kn50's on your network, I bet you are having the same retrans problem. Same problem here but with an AP1000 with indoor amp running Version 4.43 karlnet I restart the amp traffic comes ba
All RG's(65 users) with the latest firmware retransmits are mostly 10 % or less but I have a couple that are 20%. Using the Demarctech 100mW card into the YDI amp and then 90 ft of cable 15dbi omni.
Yup, we are having the same type issues. Have replaced the KN-205 and KN-105 boards at two locations. Tried three different 4.44 releases and even went back to 4.43 on one. None of the releases has s
Interesting the suggestion about the increased power, another person l know running a solar site is also looking at moving to 24v. He has done some bench testing and when the voltage drops to just ov
I Have this same issue on my ap1000 with a mix of rg1000 clients and kn50 clients.... Its been going on for months and I would call it an ap LOCK UP... and if you look at any of the CPEs you will see
I am using an AP1000 and have the SAME issue, so I don't see how power is an issue [mailto:karlnet-bounces@WISPNotes.com] and is a the every they the management -- [This E-mail scanned for viruses by
Hi Phillip, Use PoE. I believe you can go as high as 48vdc that way. I have one KN-205 WIPOP at 24-28vdc now, PoE, and moving the other WIPOP over to 24vdc from 12vdc (solar) this summer. Norm ______
I do not feel its a power issue, at least on our end. We are using POE at the relay point experiencing this but its only about a 30' cat5 run and we are using 15v 1a power supplies and that's plenty.
Yup, we are having the same type issues. Have replaced the KN-205 and KN-105 boards at two locations. Tried three different 4.44 releases and even went back to 4.43 on one. None of the releases has s
Its not power. Yup, we are having the same type issues. Have replaced the KN-205 and KN-105 boards at two locations. Tried three different 4.44 releases and even went back to 4.43 on one. None of the
It's extremely odd...I have one case in which power made a difference: It was a KN100 and had a Motorola Canopy Power Supply on it 24v 400ma (I know, not enough amperage) that our vendor shipped with