Bob, We are running slightly behind schedule. It is presently being tested. Release will be ASAP. KarlNet Technical Support http://www.karlnet.com/Support/Supportmain.htm 614-822-5275 x 128 Wasn't th
Rachael, Our 5.8 products are slated for release sometime in Q2 of this year. KarlNet Technical Support http://www.karlnet.com/Support/Supportmain.htm 614-822-5275 x 128 Hi Matt Kolbo asked the quest
Jason, When the KN-50 shows up as compatible, one of the following is in question. The channel, Network ID or System Access Passphrase does not match. Keep in mind your Base must be set to TC ISP Bas
Caleb, Please check the manuals available on our website for the answers to your questions for the KN-105/205 at: http://www.karlnet.com/Documents/DocumentsManuals.htm KarlNet Technical Support http:
Larry, Look for this functionality in the next release of our software. It is presently slated for release some time in Q2 this year. KarlNet Technical Support http://www.karlnet.com/Support/SupportK
Dan, AS I understand some of the changes made for the KN-xx5 series was to increase the processor speed to 133 from 100Mhz. The clock for the RAM was decreased to 66Mhz. We are not aware of any signi
Roberto,this card is NOT supported by SC-4700 NDIS, please see below: PRESS RELEASE KarlNet Announces Low-Cost Hardware Replacement to SC-4700 Client Drivers Dublin, OH ? September 15, 2003 ? KarlNet
Try attached method. --Original Message-- From: karlnet-bounces@WISPNotes.com [mailto:karlnet-bounces@WISPNotes.com]On Behalf Of helio@compuland.com.br Sent: Wednesday, November 12, 2003 9:01 AM To:
This feature(NAT/DHCP) has been returned to the license-it site. We apologize for any inconvenience this may have caused. Thanks for all the valuable feedback!. KarlNet Support RLM Just FYI, not tryi
To enable WARP in ver 4.44 you must first regenerate your key on license-it site. During key re-generate select/enable WARP option. There is NO CHARGE to add this option, this is the introduction per
Sergey, Was this a new install? If not did you regenerate your license key? Ed KarlNet Technical Support http://www.karlnet.com/Support/Supportmain.htm 614-822-5275 x 128 --Original Message-- From: k
yup...is karlnet sleeping? I sent an email to support (like Kevin requested) a few days ago......I realize it's a holiday week but ....are there that many support e-mails to attend to? I can't imagin
All, KarlNet Technical Support/Services never sleeps. We apologize for the delay of email responses, we will address all ASAP.The holiday season and end of year processes has delayed email responses.
All, Kevin Knuth has exited the list!. My name is Reg Mallory, I am the Technical Services Manager with KarlNet,Inc. I will monitor and respond to this list at every opportunity. My goal is to perfor
These parameters were tested with -79dbm rx sensitivity or 24Mbps OFDM rate in G-mode. At this scenerio, the average PtP throughput was 14.75Mbps.The PtMp yielded 11Mbps average, with six satellites
Dan, the Dev. Engineer is onsite this week reviewing ALL submitted information. The moment that I receive an update I will provide/relay the solution. The Testlab has replicated the issue and provide
Brett, We have provided this information on our web site. Here is the URL: http://www.karlnet.com/Product/ProductFlashROM.htm EvD KarlNet Technical Support --Original Message-- From: karlnet-bounces@
Dan, The KN-205 are designed with an operating temperature of 185 degrees Fahrenheit. All KN-2xx units sold know are the 205 is this not suitable for your situation? Thanks, Ed KarlNet Technical Supp
All, J3 is a constant supply point. I believe what Norm is looking for is the P3 header on the KN-xxx. Pin 1 is ground and pin 2 is hot. This will supply voltage to a 5v fan, that is controlled by co
Norm, That is correct, notice KN-xxx, obviously a KN-50 and it's later versions would not, as it would be generically referred to as KN-xx. KarlNet Technical Support http://www.karlnet.com/Support/Su