To enable WARP in ver 4.44 you must first regenerate your key on license-it site. During key re-generate select/enable WARP option. There is NO CHARGE to add this option, this is the introduction per
Peter, We have reviewed your email thoroughly. I think there may be some misunderstanding on how TurboCell operates and how it differs from 802.11b. Please review the following for more information:
Paul, I understand this is frustrating and we are and have been attempting to resolve it as quickly as possible. We always appreciate factual, complete and consistent information in regards to issues
All, Software releases are planned to be available for the KN-50 as soon as the license-it.com website infrastructure has been modified to add support for it. KarlNet Technical Support http://www.kar
Timothy, there is nothing conclusive pointing to radio firmware and the specific issues mentioned. I am not discounting what you have mentioned but at least from our point of view there has been noth
Peter, The firmware versions loaded over time have been 6.08, 7.52, 8.10 and currently 8.74. The radio card itself could have any of the versions in between 6.08 and 8.75 and one of the versions ment
Peter, I believe there is a misunderstanding. If you point two radio antennas at each other or place them too close to each other on the same channel and they are not authorized to associate to each
Peter, The KN-50 uses the firmware on the radio card. The newest cards from Orinoco are not in compatible in the KN-50 because of firmware, specifically they are different radios and do not use the s
Caleb, The KN-105 has not yet been released. A KN-105 will have a white label on the ST-PC processor, on that label will be a number "BA200-0107". This means the unit is a KN-105. KarlNet Technical S
Thanks Brett,a couple additional questions for Promo What radio are you using in the Ubicom(KN50?) device? Are you able to capture the traffic during high ping times? If you are able to analyze the t
All, The engineering release of the Configurator has the ping fill test enabled. This is normally not enabled because it completely kills the wireless network during the test. If you would like to ac
This list is from the KarlNet Knowledge Base. This archive will be available to ALL March 15, 2004 with guest/guest- login/username via http://www.karlnet.com/ACASP/loginform.asp . We are currently u
That is correct Rick, March 15. Reg Mallory I was told yesterday that the website would not be online until March 15. Reggie can you confirm! Rick Harnish OnlyInternet Broadband & Wireless, Inc. Logi
Brad, thanks for the feedback. I will share this with the KarlNet Staff, and management. Reg Mallory Technical Services Manager KarlNet,Inc KN=response from Reg Mallory OK, attempting to get things s
KarlNet Announces Low-Cost Hardware Replacement to SC-4700 Client Drivers Dublin, OH - September 15, 2003 - KarlNet, Inc., the leading solutions provider for the wireless broadband market, announced
Hello Bob,the KarlNet Support staff is gathering statistics at a problematic site north of Columbus, Ohio . They are equipped with bins for the original KN-50.The successful information obtained will
Caleb, I have forwarded this email to our Production Manager. ALL KarlNet hardware is tested by the manufacturer, I am not sure how many inspection "points" items that are required but I can assure y
On an SEC-AP setup, the MAC address put into the ACL of the AP applies to SEC client itself as well as the MACs behind the SEC. So in order to allow all the SEC and the MACs behind the SEC, one will
Are you trying to connect the Linux machine wirelessly to a TurboCell ISP base station?.If not what mode is the interface in that the Linux machine is wirelessly linked(freq,Net ID,?Have you checked
http://www.hyperlinktech.com/web/cable_radio_pigtails_list.php Hello there I got some to test with karlnet but the reverse MMCX connector pigtail I have here didn't plug well on the card can any of y