Jim, are you sure that you have the right password? I got thrown by the error message for wrong password, which is the "timeout" message. Be sure to double check the pass you are trying for your RG.
Ah, that problem. Dan, I had a similar situation using the PRISM II 100mW card in my PtMP slot on the AP using v4.02 about month and a half ago. (opposite situation). The signal at the CPE was great,
Checked my notes, Dan, and I was seeing about a 20dB difference between remote and local signals with the 100mW card loaded in the PtMP slot. Norm home
The link seemed solid...however, sometimes the reported S/N ratio would drop below 0 and the link would just quit. I suppose the code in Karlnet looks for this situation and drops the link...even tho
Tony, I tried your 100mW PRISM 2.5 cards in TC v4.02/AP-1000/SA-4400, and while the signal gains at the CPE's were impressive (7-8dB reported from the CPE Orinoco radio on average), the reporting fro
Ok, but with one clarification, _both_ signal and noise are not reported correctly. It would be very nice if TC could read the card, or a firmware fix could make it so. Do you know the status of othe
Tony, you need to put pressure on the manufacturer of the PRISM 2.5 cards to get the firmware problem with TC corrected. If you don't then both Dan and I are holding some fairly crippled hardware we
I recently got a PRISM II 100mW radio from Demarktech to try in our AP-1000 running Karlnet TC. The output power was the draw, as it was either that or amps, which I wanted to avoid for certification
Simple question. What constitutes a good TC link in terms of the ratio between Transmit and Re-Transmit numbers as seen in the "Remote Wireless Entries" (under Monitor->TurboCell Station Entries)? I'
Doug, I believe that this card is the SL-2011CD PC Card (Senao). Can you recommend any well behaved 100mW PRISM II cards, or is it recommended that we go the SBC route with Karlnet TC on flash? I'm w
Charles, can you elaborate on the $300 Karlnet CPE? Is it outdoor/PoE? What sort of radios will it accept? PRISM II? Just Orinoco? Specs, prying minds want to know...and buy if suitable. Norm (we
I'm going to pull this PRISM II 100mW card, as I've discovered that the reporting of the signal strength at the AP (PRISM II, Karlnet TC) is accurate--and extremely low. I'm seeing signal strengths t
Yes, please, is anyone else deploying this card with Karlnet TC? I'd love for the problem to be other than this card, as I really, really need that output power. I'm really surprised at the receive s
Bill, I'm seeing a S/N ratio much lower. Both signal and noise are much depressed over the Orinoco card...but for that matter, running the SOM for a link of 7.5mi with 20dB xmit power into a 15 dB an
Barry, I await your results with 'bated breath. I'm going up to our AP this afternoon to put the PRISM II card in the backhaul slot to see if I get similarly lousy results, as it's a known good. I'm
Hi Tony, Yes indeed, it's running Karlnet TC. What made me think that the information can be trusted (after initially thinking otherwise) is that in areas that I'd previously with the Orinoco radio h
Well, I took the 4X4 up to the AP this afternoon and I swapped the PRISM II 100mW card from the PtMP position into the PtP position this, a "known" good situation. It made a rather amazing difference