We use a KN50 and a $50 router for the Nat, DHCP still a cheap solution. Regards Mark McKibbin DCS Internet 64 Queen St Warragul Victoria 3820 Australia www.dcsi.net.au mark@team.dcsi.net.au Ph. 1300
The KN 50 just a board, although it has POE you don't have to use it, you can put a high power card in it so its OK with longer cable runs. Just my 2 cents.. Regards Mark McKibbin DCS Internet 64 Que
Karlnet seem to be supplying Dell/Agere cards I assume surplus they seem to be a good price. Regards Mark McKibbin DCS Internet 64 Queen St Warragul Victoria 3820 Australia www.dcsi.net.au mark@team.
I can't find them on the Agere site or the Dell one Regards Mark McKibbin DCS Internet 64 Queen St Warragul Victoria 3820 Australia www.dcsi.net.au mark@team.dcsi.net.au Ph. 1300 665 575 (Help Desk)
It didn't make it, can you send it to me direct. Much appreciated Regards Mark McKibbin DCS Internet 64 Queen St Warragul Victoria 3820 Australia www.dcsi.net.au mark@team.dcsi.net.au Ph. 1300 665 57
How do you work these updates it seems that they are can't see the dell as an Orinoco/Agere card. Regards Mark McKibbin DCS Internet 64 Queen St Warragul Victoria 3820 Australia www.dcsi.net.au mark@
After reading this thread I went out and ran some tests here are the results, these were all done at the same location 3.6Km from ISP base station a new site (no other users) Dell Card V8.10 Ping wit
We have just set up a new network so far with 6 clients all with KN 50. I have 2 clients with very high retransmit rates (one is about 50%) but they have good SNR at both ends infact better than othe
We rate limit our customers to a max of 512K so would it be an advantage to reduce the Radio transmit rate to a lower rate and witch end do I do it? As I assume we will get better receive sensitivity
I have a KN200 delivered early December that just puts out power to the header at any temp, but it does now tell me temp in the configurator my old one does not even do that. Regards Mark McKibbin DC
We use prism 2.5 cards in KN50 with no problems except no SNR values on some brands and weird ones on others.....also they work much better than the Dell cards supplied with virtually no failures and
We have them in plastic enclosures and they are working OK at 40 degrees C also they have a mix of Dell and 200mW prism cards Regards Mark McKibbin DCS Internet 64 Queen St Warragul Victoria 3820 Aus
Apart from the wrong SNR values they work well, no lock ups, and we had a hot December. Regards Mark McKibbin DCS Internet 64 Queen St Warragul Victoria 3820 Australia www.dcsi.net.au mark@team.dcsi.
Just wondering what current the P3 header will switch? Regards Mark McKibbin DCS Internet 64 Queen St Warragul Victoria 3820 Australia www.dcsi.net.au mark@team.dcsi.net.au Ph. 1300 665 575 (Help Des
Where did you get the GSM reseting device? I've been looking at one but they wanted too much money for it. Regards Mark McKibbin DCS Internet 64 Queen St Warragul Victoria 3820 Australia www.dcsi.net
We have been up to 69C no reboot last summer before I put a fan in. Regards Mark McKibbin DCS Internet 64 Queen St Warragul Victoria 3820 Australia www.dcsi.net.au mark@team.dcsi.net.au Ph. 1300 665
Is that 24V to the POE or the power socket on the board? Regards Mark McKibbin DCS Internet 64 Queen St Warragul Victoria 3820 Australia www.dcsi.net.au mark@team.dcsi.net.au Ph. 1300 665 575 (Help D
Does anyone know if I can purchase KN50 with 802.11b (not Turbocell) its for a couple of our original networks that were not TC. Regards Mark McKibbin DCS Internet 64 Queen St Warragul Victoria 3820
I assume "Ultra Bridge" is not Turbocell so is there a separate build for prism 2.5 for TC? Regards Mark McKibbin DCS Internet 64 Queen St Warragul Victoria 3820 Australia www.dcsi.net.au mark@team.d
I wondering what everyone else does to determine where your strongest signals are coming from at a customers premises, other than trying different access passphases in a CPE. Regards Mark McKibbin DC