I am working with an engineer who is working on an ethernet connected monitoring solution. This device will be able to monitor analog voltages, temperature is only one application, to monitoring or c
Cable loss works in both directions. Yes, the amps have a receiver preamp built in to make up for cable loss going back down to the radio, however, it is better to NOT lose any more signal than neces
We are running Karlnet board with Teletronics 200mw card and an Orinoco 32mw card in a metal box high on the tower with a 120mm muffin fan blowing across both cards. The box is sealed and has been su
I have 3 AP1000's that have the same problem. The PCMCIA controller chip is damaged, I am attempting to replace it, but it is verrrrrry difficult as it is a 208 pin flat pack IC. I will post with res
Charles is right, I have only praise for for him and his organization and have had no complaints. software/information, out first that may (but need. (most on my _____________________________________
I have a KN205 that replaced an AP1000 with approx 40 subs. Thru-put appears to be much better, but I don't have any numbers to support it. I just watch the STG graph and it show much more usage... _
Digi-Key has lots of fans. I use a 24vdc ball bearing fan on my KN205's. I don't use the header yet, but plan to investigate using it. the where _______________________________________________ Karlne
Charles is right, I have only praise for for him and his organization and have had no complaints. software/information, out first that may (but need. (most on my _____________________________________
Where can I get the New Version 5 configurator. It is not listed in license-it.com. versions http://www.karlnet.com/Documents/ReleaseNotes/KarlBridgeKernelReleaseNotes.h _____________________________
I am concerned about your AP1000 problems, how can I tell what hardware version I have remotely? I have 2 in service that I'd like to upgrade, but don't want to render them useless and have to drive
We just went thru the same thing on our network. We have over 250 customers and all were bridged. Something would trigger a broadcast storm and the whole network "felt" it. It was really causing havo
on the right track putting the ground wire to the top of the tower. I suspect rusty joints more than the paint. Check out "Cadweld" at your electrical distributor. This is a means of attaching the g
Also check out www.soekris.com for their net4501 board and case. You can install a compact flash with the Mikrotik software loaded on it (you can even buy it from them preloaded on a compact flash).
We have about 100 RG1100 and AP1000's in service in Oklahoma and nary a heat problem. The AP's have fans to circulate air inside the 24" x 24" box. The CPE RG's are in 8"x 8" box with no fan. Steve -
The input capacitor rated voltage is 16 volts DC. If you stay below that, you will be fine. The regulator itself is good for up to 40 volts. The Apple Airport is almost the same as an RG and has a hi
Bob, They had various problems, the caps fixed most of them. I have a Macintosh as well and using it, I can reflash the firmware very easily. A lot of the time the firmware is corrupted as well. I th