Seems like I read here that there are some issues with the ethernet port of an AP-1000 running KN. I have an AP-1000 that has at least 7% packet loss communicating on the ethernet interface only. Out
I'm using 4.02. I've been seeing a lot of traffic about newer versions causing other big problems. This is the only one I've had problems with to date and I have 6 deployed. Very frustrating having a
Guys, Can anyone help me with the list admin duties? Mostly just a matter of dealing with messages that arrive from people who aren't subscribed to the list or people who subscribed with a different
I'm trying to make a 22 mile link happen on 2.4Ghz. Here is the set up: Site-A -- AP-1000 (tower mounted) with 10' of LMR-400 with a 180mw PRISM card to a 24dbi Connifer Grid dish (horizontal pol). S
Noise has never been a problem here. I'm constantly amazed at how little RF there is on 2.4Ghz around my area. Lots of trees I suppose. I've tried this link on two channels thus far. I've tried a Lu
Yep, I tried a Lucent card thinking the same thing. But I've got another link that is driving the same brand/model amp with a 180mw card on an even shorter link and it works great. So I don't think
This is what I'm seeing exactly. Your 180mw Prism cards have better ears than the Lucents. I have two AP-1000's using your two of your 180mw cards in each. Both work great. The one at point-B has on
There isn't enough signal to get a number Tony. It doesn't report anything anyway. I don't think it is a metering problem. I was only able to even see the other side after much tinkering with the po
Dear Mr Karlnet, I wish that the Config program had some method of doing a site survey of even a single channel in some graphical way. As it stands, I believe the only way I can determine my noise fl
In all versions of the Configurator that I have here, the following occurs: Wireless Link Test --> Explore --> Link Test Now, if you happen to lose the link (aligning antennas or whatever) you have t
A very weak link, so likely it might have still been trying. Regardless, if I hit <Cancel>... it should cancel. BTW, I've seen this same behavior before and I had to close the config program and re-
I was trying to make a 22 mile link happen between two mountains. All the calculations looked good, but I couldn't make it happen. On one side of the link I could see the other side when I did an exp
I have an AP-1000 that is on a tower that I flashed again this afternoon after a screw up. After I upload the software, it reboots but is not pingable. Yet, it will show up when I do an arp -a from m
Read the archives last night after sending this message. Sorry for the dupe. I'm going up there right now with a hub to see if I can get it to work instead of the cheap switch I have there now. I'll
Trying to figure out how to do a POE tower mounted system for a back haul that will run the 185mw cards. I tried a Teletronics box, but it didn't like it. Thanks bill