So if your operation chooses not to abandon turbocell stuff, what do these guys want you to buy? In other words, if hypothetically one was to completely submit to YDI's wishes and continue with 2.4 a
Hello all, Anyone recognize the following issue: SEC client on RG-1000 associated and communicating with KN-205 interface set up as 802.11 compatible AP. RG-1000 drops of associated station entries.
Hello all, I have a couple of clients using Microsoft VPN,s that have the tunnel basically drop a few minutes into the session. All of the necessary layer 2 protocols are open. I have other customers
Sorry for the simple question, but what license is used for repeating turbocell from a base station? How are the interfaces set up? I'd like to do what is described in the WRU sku from Karnet. Thanks
I just picked up a few OR-1's and AP-500's. Do you use the same license/bin files as you would on the RG-1x00 hardware? Thanks, David _______________________________________________ Karlnet mailing l
I've been getting errors when i try to post... _______________________________________________ Karlnet mailing list Karlnet@WISPNotes.com http://lists.wispnotes.com/mailman/listinfo/karlnet
It's weird, if I mail to karlnet@dayton.akorn.net I can post. If I mail to karlnet@wispnotes.com I get this ..... -- Transcript of session follows -- ... while talking to paris.akorn.net.: <<< 450 <k
If you have insight or advice, please reply or cc directly to me, I think the list server config is somewhat horked... I'm a small shop so far, a little over 40 subscribers. I was cruising along nice
Little more info.. - AP's are KN-105's ISP base stations temperature is always good - cards are SMC 200mw prisms - each sector has RFLinx channel filter - clients are KN 105/205 with SMC 200 mw cards
Hello Dan, Thanks for the reply. The thing that stands out on link test is the signal and noise local to the base seem too low. A link just a couple of miles away with pretty good LOS is showing -95n
Thanks, Martin. I'm routing everywhere, no bridging. Don't think it's a broadcast storm thing. I watch all CPE interface counters, no particular spewing of traffic by any one guy. ___________________
Hi Blair, Is this turbocell client full blown tcell? Can I route, nat, firewall, yadayada? My network is all routed, I insist on NO bridging. If you've got these capabilities, and not just something
All of my SMC cards show SNR of 1 at the local level. They are working fine, but it's kind of a pain to log on to the far end of a link to see the close end's local. I'd like to know the firmware tha
Hello all, Pretty basic question here, is the 10% threshold referring to a percentage of the total *bytes* shown in In octets, OR is it the sum total of *packets* shown In unicast and In non-unicast?