Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Amps\]\s+solid\-state\s+amp\s+\"suckout\"\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Amps\]\s+solid\-state\s+amp\s+\"suckout\"\s*$/: 6 ]

Total 6 documents matching your query.

1. [Amps] solid-state amp "suckout" (score: 1): Author: Scott Townley <nx7u@cox.net>; Date: Thu, 10 Aug 2006 16:13:59 -0400; I have a broadband, solid-state amp that seems to have a large-signal "suckout". The small-signal gain across the HF band is as expected, 10.5dB decreasing to 9.5dB at 30MHz. But under full drive, th; /archives//html/Amps/2006-08/msg00387.html (7,416 bytes)
2. Re: [Amps] solid-state amp "suckout" (score: 1): Author: Steve Thompson <g8gsq@eltac.co.uk>; Date: Thu, 10 Aug 2006 21:34:35 +0100; What are the modules? Resonances in the transformers or feedback networks can cause this, but be prepared for your amplifiers to have unique problems. It might be that the fundamental frequency load; /archives//html/Amps/2006-08/msg00388.html (7,499 bytes)
3. Re: [Amps] solid-state amp "suckout" (score: 1): Author: "m.ford" <k1ern@pioneerwireless.net>; Date: Thu, 10 Aug 2006 18:51:29 -0400; Perhaps "full drive" is actually overdrive? Mike k1ern _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps; /archives//html/Amps/2006-08/msg00389.html (7,502 bytes)
4. Re: [Amps] solid-state amp "suckout" (score: 1): Author: "Tom W8JI" <w8ji@w8ji.com>; Date: Thu, 10 Aug 2006 19:12:12 -0400; I thought the same thing. The problem is the load impedance presented by the transformer is always frequency dependent. If it goes through a peak at a certain frequency, the PA can saturate easier.; /archives//html/Amps/2006-08/msg00390.html (7,207 bytes)
5. Re: [Amps] solid-state amp "suckout" (score: 1): Author: "Will Matney" <craxd1@verizon.net>; Date: Thu, 10 Aug 2006 16:20:15 -0400; Scott, Suckout meaning? Is it that the power is dropping below where it should be? Best, Will ** REPLY SEPARATOR ** On 8/10/06 at 4:13 PM Scott Townley wrote: ________________________________________; /archives//html/Amps/2006-08/msg00393.html (7,983 bytes)
6. Re: [Amps] solid-state amp "suckout" (score: 1): Author: mike kendall <ke6cvh@yahoo.com>; Date: Thu, 10 Aug 2006 21:13:30 -0700 (PDT); Scott, The impedence may be different under full load on the output. I have read on some solid state amplifiers where they have fine tuned the power supply voltage to achieve maximum efficiency for 5; /archives//html/Amps/2006-08/msg00394.html (8,030 bytes)

Current List: 1 - 6
Page: [1]