Search String: Display: Description: Sort:

Results:

References: [ +from:n6tv@arrl.net: 36 ]

Total 36 documents matching your query.

21. Re: [Amps] Fwd: Re: Modern rig amplifier keying (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Sun, 21 Jul 2019 12:27:57 -0700
Stan, Congratulations on getting this to work, but like most other modern radios, the TS-590SG has an option to enable an internal mechanical relay to key amplifiers that required more than 10ma. Unf
/archives//html/Amps/2019-07/msg00024.html (10,477 bytes)

22. Re: [Amps] re interfacing IC-706 to alpha 9500 (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Tue, 12 Nov 2019 23:49:18 -0800
HSEND is TX GND for HF/50 MHz. VSEND is TX GND for VHF/144 MHz. So use HSEND. Maximum current is 20 ma. If you use a milliameter to short the Alpha 9500 KEY IN line to ground (with amp. in OPERATE mo
/archives//html/Amps/2019-11/msg00067.html (8,401 bytes)

23. [Amps] For Sale: Alpha 76A heavily modified to work on 6m only (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Sat, 9 May 2020 16:53:44 -0700
For Sale: - *Alpha 76A Heavily Modified to work on 6m Only - $800 or Best Offer* Two (2) 8874 tubes. Puts out about 700 W max. Tested with dummy load only. Tunes from 50 - 51.5 Mhz. Very quiet blower
/archives//html/Amps/2020-05/msg00004.html (7,965 bytes)

24. Re: [Amps] UM4001CR pin diode source - or Alpha 86 vac relay mad (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Fri, 7 Aug 2020 13:55:15 -0700
If the receiver goes dead when you switch the Alpha 86 from transmit to operate, it usually means the LittleFuse on the receive pin bias board has opened. Check that first. It's easy to replace; just
/archives//html/Amps/2020-08/msg00025.html (9,251 bytes)

25. Re: [Amps] UM4001CR pin diode source - or Alpha 86 vac relay mad (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Fri, 7 Aug 2020 13:56:27 -0700
Correction: I meant to say, if the receiver goes dead when you switch from STBY to OPER, replace the LittleFuse. 73, Bob, N6TV _______________________________________________ Amps mailing list Amps@c
/archives//html/Amps/2020-08/msg00026.html (9,580 bytes)

26. Re: [Amps] UM4001CR pin diode source - or Alpha 86 vac relay mad (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Sat, 8 Aug 2020 08:22:37 -0700
Dick Byrd, N4UQ. Great service on Alphas! http://www.n4uq.com/ 73, Bob, N6TV _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/
/archives//html/Amps/2020-08/msg00033.html (8,270 bytes)

27. [Amps] For Sale: Ten-Tec Titan 425 with grid protection mod (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Sat, 15 Aug 2020 08:20:09 -0700
For Sale: Ten-Tec Titan 425 HF Amplifier with unique grid protection mod. Works perfectly. Details and photo links here: https://www.eham.net/classifieds/578385 73, Bob, N6TV ________________________
/archives//html/Amps/2020-08/msg00043.html (6,650 bytes)

28. [Amps] KPA1500 Efficiency vs. RF-Kit B26 (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Sun, 11 Jul 2021 18:55:59 -0700
The 51.9% efficiency appears to be worst case at 1500W output. The efficiency of the KPA1500 (Pout / Pin) varies from amplifier to amplifier and from band to band. The same may be true of the RF-Kit
/archives//html/Amps/2021-07/msg00041.html (8,299 bytes)

29. Re: [Amps] KPA1500 Efficiency vs. RF-Kit B26 (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Sun, 11 Jul 2021 21:11:06 -0700
They are listed in the ARRL Product Review: http://www.arrl.org/files/file/protected/Group/Members/ProductReview/PROD_REV_0319.pdf Spurious and harmonic suppression: HF, 62 dB typical, 48 dB worst ca
/archives//html/Amps/2021-07/msg00043.html (8,330 bytes)

30. Re: [Amps] KPA1500 Efficiency vs. RF-Kit B26 (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Wed, 14 Jul 2021 20:58:31 -0700
K4 questions are best directed to the K4 Discussion Group: https://groups.io/g/Elecraft-K4 rather than Amps. Thanks. 73, Bob, N6TV _______________________________________________ Amps mailing list Am
/archives//html/Amps/2021-07/msg00067.html (9,193 bytes)

31. Re: [Amps] ft-2000 vs pgxl (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Wed, 8 Sep 2021 17:05:05 -0700
The *QST *review says the TX Delay of the FT-2000 was measured at 35 ms on SSB. See http://www.arrl.org/files/file/protected/Group/Members/ProductReview/pdf/pr0702.pdf . For the FT-2000D it is 37 ms
/archives//html/Amps/2021-09/msg00002.html (9,682 bytes)

32. Re: [Amps] QRO Technologies HF2000 plate choke, cont. (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Fri, 12 Nov 2021 07:47:31 -0800
The W8JI business website is https://www.ctrengineeringinc.com/ 73, Bob, N6TV _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman
/archives//html/Amps/2021-11/msg00014.html (8,998 bytes)

33. Re: [Amps] Remove Me from This List (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Mon, 7 Mar 2022 15:56:54 -0800
You have to do that yourself, here: http://lists.contesting.com/mailman/options/amps 73, Bob, N6TV _______________________________________________ Amps mailing list Amps@contesting.com http://lists.c
/archives//html/Amps/2022-03/msg00011.html (7,390 bytes)

34. Re: [Amps] ETO/Alpha 76 Tri-tube (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Sun, 16 Apr 2023 13:43:17 -0700
The Switchcraft 3502A is still available from Mouser and other sources. https://mou.sr/40OUcg6 73, Bob, N6TV _______________________________________________ Amps mailing list Amps@contesting.com http
/archives//html/Amps/2023-04/msg00025.html (7,519 bytes)

35. Re: [Amps] AE9K Alpha Monitoring Program Web Site? (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Mon, 20 Nov 2023 23:13:28 -0800
For info. about identifying, renumbering, and relabeling COM Port numbers displayed by Windows Device Manager, see this presentation linked from my QRZ.COM page <https://www.qrz.com/db/N6TV>. - Every
/archives//html/Amps/2023-11/msg00032.html (10,524 bytes)

36. Re: [Amps] Pulsing SWR Meter (score: 1)
Author: "Bob Wilson, N6TV" <n6tv@arrl.net>
Date: Tue, 26 Dec 2023 22:56:40 -0800
Try yet another battery. If you see the same symptoms, check the 9V battery cap and the wires that lead from it; maybe only a few strands are left. I had to splice a new cap into one of my Nye Viking
/archives//html/Amps/2023-12/msg00048.html (8,488 bytes)


This search system is powered by Namazu